CSX25DPBBAA Hotpoint Refrigerator - Instructions

bought new left rail removed old one with a screw driver and replaced with the new one

I saved about $15.00 by ordering the part on line. It came in about a week and was a super easy process. Since it was just missing there really wasn't anything that needed fixing. just installed it where it belonged and all was good. Great and easy experience.

Removed the top hinge of the right-hand door, removed the door, replaced the cam riser on the bottom of the door, then replaced the door and top hinge. Simple and easy.

Went to GE website and researched the problem for the model, determined that it was 90% sure it was the Ice maker, I ordered it and it arrived the next day, installed it and it began working immediately,

I watched the video and did the job as instructed. It was very easy and worked as expected. The video was the key.

I found the drawer slide rail for the left side and ordered it. It was delivered in a couple of days and it was fixed in 3 minutes. Partselect provided the best customer service we have ever received. Great Job! Thank you so much!

Removed ice select control unite from freezer by removing 3 nut screws holding unite in place. Disconnect 2 electrial plug ins.Remove unite from freezer and place on table for easy work space. Remove 4 nut screws holding Solenoid & Arm. Replace with new Solenoid & Arm. Reinstall back in freezer and now we have cube ice again.

followed the previous posts, loosened four screws on the front panel, attached panel to new auger and ice bucket, and was good to go. Excellent advice!

Removed drawer cover, removed both drawers, unscrewed broken part, installed the new one, put drawers and cover back.

Repair was easy. All working now.

watched a 2 minute video on installing the connector. Then using the utlity blade cut out a 1/3" section of the tubing and installed the connector. DONE! Leak fixed

I followed the video instructions. They were clear and consise. I removed the trim ring and controls. Them removed the housing and flapper. I did notice a small burr in the plastic chute and foam insulation. I trimmed this off with a utility in hopes this burr caused the flapper to warp. This is the 2nd time the flapper has been replaced in 1.5 yrs. The repair was really easy thanks to the video.

removed 2 screws from broken slide, then I positioned the new slide in place and using original screws secured slide to wall of frig.

remove 3 bucket screws. 1 bracket screw slide bucket back insert drive reverseb steps

I ordered the part and it was replaced. I always worry that I will get the wrong part or it will not fit. The on-line help with the model number gave me the right part, and this was an easy repair. Gusessing that I saved over $100 from needing to call a repair service!