CSM25MRCEWW Hotpoint Refrigerator - Instructions

Empty all the good stuff stored in the door. Remove top hinge, lift off door. Remove bottom hinge from door and refrigerator, replace with new hinges. Replace door and reinstall top hinge. Very simple. Worst part was removing all the stuff stored in the door then putting it back! My parts arrived very quickly and I'm very pleased with Part Select.

opened back panel and replaced valve verry easy

With my wife's help, we emptied the door shelves and removed the door to the kitchen table. The video and instructions for replacing the parts were 100% right. We probably spent more time cleaning the door bottom and gasket than actually changing the hinge assembly! The job went very smoothly and saved us from overspending on a repair to this old fridge, or worse, making a quick decision on buying a new one.

I viewed a how-to video on partselect.com. I removed all items from the door shelves. Used a screw driver to remove the top "hinge" plate. Used a nutdriver to remove the door hinge plate. Removed door, laid on it's side-hinge side up (if you don't have a helper, lay it on a flat service). Simply removed the broken bottom plate and replaced with new part, and reinstalled on refrigerator. Super Simple!

Removed 4 screws from the old rusted ice bucket ( they hold the cover on) installed the cover and screws in the new ice bucket and installed the new unit in the freezer .

Ordered new Ice Maker from you and fixed the problem completely.

Followed the video, very simple

I watched the video on the partselect website once and completed the repair. Very easy!

The trim piece covering the opening of the dispenser is the first and most difficult part of the disassembly. Take care when removing this piece that it does not break.

just i took off the actuator and replace with the new one in 8 minutes.It was so easy.

Watched video on the parts order information page and did the repair. Very helpful made me feel like I could do the repair

First, depending on when you find out your problem, be prepared to toss out spoiled food. Unplug the unit. Since you must allow the ice build up on the coil to melt, be prepared for water. Use towels placed under the coil in the freezer to soak this up or it will end up on the floor. Remove ice maker bucket as the ice will melt, that is if there is any. In my case the defrost timer was bad but I later learned that my defrost heater was also bad. Do yourself a favor and change both the defrost timer and defrost heaters. This issue is generally an age issue so replacing both will give you peace of mind. Also, clean the whole freezer as this is the time to do it. You will be surprised at the ice maker bucket cleanliness. Time to prepare and clean is what takes additional time. Time to repair is short and simple. One last thing, when replacing the defrost timer try not to mess with the temp. control slides as you will have to put them back in the proper positions for reassembly of the cover.

Solenoid pushing the crushed ice flapper was burned out. Solenoid was easy to find unplug and replace. I used the old piston which simplified things. Now works great

A very simple install. Requires the removal of 4 screws and plugging in new heating element refer to the excellent diagrams provided on line

Ordered this part after i replaced the plastic tubes on the back as the problem persisted. loosen the nuts holding the water inlet lines, remove the cover to the valve. remove the valve and the water inlet line to the the valve. Disconnect the 2 outlets from the valve. 1 outlet to icemaker and other outlet to water cooler (bigger). Connect water inlet and 2 outlets to the new valve, test the water lines. Found the inlet is leaking, removed it and added teflon tape and reconnect it. All is done. Then I left the freezer door open for 3 hours to melt the ice on the wrong places and all is well.