Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS964306
This part works with the following brands: GE, Hotpoint & Kenmore.
Replacing servo was not hard, but did not solve problem. Searched some more and the cure is to remove the light bulb from the dispenser. Seems that old bulbs draw too much current and cause the control panel to fail in sending signal to icemaker motor. Removing the bulb cured this fault and the control panel worked fine.
Help other customers find the most helpful instructions.
Were these instructions helpful?
remove by hand turning old and replacing new by turning by hand.Lifted out old grill and placed in new one
I took the part out of the package and placed it in the recessed water dispenser/ice maker cavity. Done!
Water line 5/16inch was severed, under refrigerator. Used union connector to join line. Dispenser plate removed using allen key to unsnap plate ,from under the plate itself. Removed screws holding solenoid valve and removed the plug from circuit board connected to solenoid. Installed new solenoid valve. Put flapper back in place, and made sure spring on left side of flapper is reattached to the opening on the flapper. This corrected all problems. Caution, keep an eye on spring that it remains in place.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.