964306-1-S-GE-WR17X11655        -Recess Grille
964306-1-S-GE-WR17X11655        -Recess Grille 964306-2-S-GE-WR17X11655        -Recess Grille

Recess Grille

PartSelect Number PS964306

This part works with the following brands: GE, Hotpoint & Kenmore.

  • Compare At

    $8.98
  • You Save

    $1.50
  • Your Price

    $7.48
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.7 / 5.0, 4 reviews What's this?
1-4 of 4
 

14 of 15 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerMark from Skokie IL

Icemaker switch on door would not trigger motor

Replacing servo was not hard, but did not solve problem. Searched some more and the cure is to remove the light bulb from the dispenser. Seems that old bulbs draw too much current and cause the control panel to fail in sending signal to icemaker motor. Removing the bulb cured this fault and the control panel worked fine.

Help other customers find the most helpful instructions.

Were these instructions helpful?

6 of 7 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

Customerron from Winter Haven FL

Filter replacement/water tray replace

remove by hand turning old and replacing new by turning by hand.Lifted out old grill and placed in new one

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 2 people found this instruction helpful

Parts Used

  • Recess Grille

Level of DifficultyReally easy

Time to do repair:1- 2 hours

Tools

CustomerMark from Ramona CA

The grill flew off going down the freeway.

I took the part out of the package and placed it in the recessed water dispenser/ice maker cavity. Done!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 4 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:30 - 60 mins

ToolsNutdriver, Screw drivers

CustomerBart from Whitestone NY

Dispenser flap for ice not closing. No water from dispenser was coming out.

Water line 5/16inch was severed, under refrigerator. Used union connector to join line. Dispenser plate removed using allen key to unsnap plate ,from under the plate itself. Removed screws holding solenoid valve and removed the plug from circuit board connected to solenoid. Installed new solenoid valve. Put flapper back in place, and made sure spring on left side of flapper is reattached to the opening on the flapper. This corrected all problems. Caution, keep an eye on spring that it remains in place.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-4 of 4