Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11743167
This fountain bracket is nine inches long. It is all white in color and it is made entirely of plastic.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
Removed damaged fountain bracket by removing the torx screw using torx head screw driver. Install new control board and new solenoid onto the new fountain bracket using existing screws. Reinstall fountain bracket to the freezer door.
Help other customers find the most helpful instructions.
Were these instructions helpful?
First unplug AC power from the back of the refrigerator and I then removed entire fountain bracket assy that hold by 3 screws. Pull toward with some angle to able to access to a plug of wires and then disconnect it. Pull fountain assy downward. Set it on work place, remove all screws and transfer wires, switch, ice dispenser controller unit,solenoid, spring, flapper...and then install them to a new fountain bracket. Please note that this problem is 100% relating to mechanism. To test this work: Hold Fountain bracket assy vertically, press a flapper,position "open" and make sure return spring is working properly (enough pressure) . Now, install this unit back to my refrigerator. During installing screws, check flapper that can shut tightly enough and secure all screws, check a flapper again. I got it right for the third time because I was not aware of some parts alignment.
Un plugged refrigerator, removed 2 screws holding the front control cover in place. Removed 3 screws that held the despenser assey in place and removed the power cable. Inspected the burnt and melted assey and got on line with parts select and chose the parts I needed and ordered them. They had it all and shipped it that day. I was back in business in about 3 days. Thanks again. You have saved me on this appliance several times.
Take off cover plate. two screws. Take out three screws holding the bracket. Exchange the parts from old bracket to the new bracket. reinstall the bracket and cover.
I replaced the broken and fried parts. And everything works great now
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.