ZBD4200D01WW General Electric Dishwasher - Instructions

very quickly

Removed the end caps by spreading the tab with a screwdriver and twisting a half turn to the inside. Remove rack. Remove old rollers and snap on new ones. Easiest repair I've ever made on anything.

taking off the little front brackets, was a little difficult. I had to have my husband do it, but it was fine and it works great now,

Place the axle inside the wheel. Mount the wheel to the bottom of the dish rack and snap the axle to secure the wheel to the dish rack. Total project time less than 5 min. Video to replace wheel and axle was very helpful for those who are not mechanically inclined.

Remove rail end pieces installed the clods on the side rails and basket put end pieces back in place. Ready for washing dishes

Take out the screws in the side of the door (~7) and pull the two door sections apart at the top. I suggest that you tape the door latch in place since it can slide out; it can be difficult to replace. Use a short stem screw driver to take out the three screws holding the sequence switch in place, and unplug the two sets of wires. Once this is completed, the sequence switch will slide out. Reversing these steps completes the installation.

Followed the enclosed directions and the video helped a lot. My model needed a different motor mount bar than in the video but wasn't hard to figure out. From shutoff of the water, unplugging, and undoing the screws under the counter and pulling the old pump/motor and installing the new pump/motor and putting it all back took a leisurely 90 minutes. Be sure to hang onto the old plastic covers for the electric leads to reuse.

Check website, order part. Hardest part was determining which was the right part. Needed the axle--I call it the hanger. I had previously called and ordered, but only received the wheel with no way to attach it. Push the axle into the wheel. Push the axle onto the rack. Since it was new, it didn't slip right on, and had to push it hard. (However, when it snapped on, three of the other wheels and axles came off.) Had to put them back on as well. Much easier, as they were older and not as snug. Total time: Took longer to open the package than put it on.

I sopped up all the water in there and pulled out the lower rack, then disconnected the electricity and water pipe and drain hose. Then I unscrewed the front kick plate/cover and removed that. Then I unscrewed two screws at top of unit from the counter top, and pulled the unit out. It is surprisingly light weight. I rolled it over on its right side, and took off the short drain hose where the flapper is, and pulled the old one off and put the new one on and reversed the procedure to reinstall. It was very easy to fix, especially with your Youtube video! THANKS

Insert the piece into wheel and snap on lower rack of dishwasher. Thank you to parts select for such fabulous service and quick delivery and fair price.

Had just a little trouble getting the end caps of the the runner bars after that it was a breeze, I am a 55 year old woman and done the job by myself

I watched the video before ordering to ensure I had the right parts. I simply followed the video. So easy! And for less than $20, the dishwasher is repaired. The upper rack was such a hassle, I was considering getting rid of the dishwasher! So glad I found your site.

Remove filter screen at rear bottom of dishwasher with 1/4 in socket, remove check valve by hand, install new check valve, reinstall filter screen. Run a load of dishes, drained completly.