ZBD3500ZZ1WW General Electric Dishwasher - Instructions

Simply followed the instructions for the part on the part page. One thing that helped taking out some screws was to remove a couple of the brackets that hold the heating element and move it slightly. I would suggest cleaning all of the gunk out of drains and clean all holes in the screens using a toothpick, etc. Be careful not to overtighten the nut for the next time you have to do this!

Clipped in new wheels and clips

Really simple. Remove old corner baffles by just lifting out and replace with new. Close door to insure the door seal aligns with the new baffles and good to go.

Unscrew old stripped out one and put in new one ..wala!! Easy repair for this old lady...

Removed dish washer from cabinet area and snapped new clip into cable and hook into support.. The time that took the longest was to removed the screws to pull the unit out of the cabinet area.. Very easy fix...

very quickly

Removed the end caps by spreading the tab with a screwdriver and twisting a half turn to the inside. Remove rack. Remove old rollers and snap on new ones. Easiest repair I've ever made on anything.

taking off the little front brackets, was a little difficult. I had to have my husband do it, but it was fine and it works great now,

Place the axle inside the wheel. Mount the wheel to the bottom of the dish rack and snap the axle to secure the wheel to the dish rack. Total project time less than 5 min. Video to replace wheel and axle was very helpful for those who are not mechanically inclined.

Ordered a new basket it was a little large as I ordered the wrong size. I just broke of the tabs that held it in and now its perfect and larger !!!! Simple and great service !!!

Remove rail end pieces installed the clods on the side rails and basket put end pieces back in place. Ready for washing dishes

Take out the screws in the side of the door (~7) and pull the two door sections apart at the top. I suggest that you tape the door latch in place since it can slide out; it can be difficult to replace. Use a short stem screw driver to take out the three screws holding the sequence switch in place, and unplug the two sets of wires. Once this is completed, the sequence switch will slide out. Reversing these steps completes the installation.

Followed the enclosed directions and the video helped a lot. My model needed a different motor mount bar than in the video but wasn't hard to figure out. From shutoff of the water, unplugging, and undoing the screws under the counter and pulling the old pump/motor and installing the new pump/motor and putting it all back took a leisurely 90 minutes. Be sure to hang onto the old plastic covers for the electric leads to reuse.

Check website, order part. Hardest part was determining which was the right part. Needed the axle--I call it the hanger. I had previously called and ordered, but only received the wheel with no way to attach it. Push the axle into the wheel. Push the axle onto the rack. Since it was new, it didn't slip right on, and had to push it hard. (However, when it snapped on, three of the other wheels and axles came off.) Had to put them back on as well. Much easier, as they were older and not as snug. Total time: Took longer to open the package than put it on.

I sopped up all the water in there and pulled out the lower rack, then disconnected the electricity and water pipe and drain hose. Then I unscrewed the front kick plate/cover and removed that. Then I unscrewed two screws at top of unit from the counter top, and pulled the unit out. It is surprisingly light weight. I rolled it over on its right side, and took off the short drain hose where the flapper is, and pulled the old one off and put the new one on and reversed the procedure to reinstall. It was very easy to fix, especially with your Youtube video! THANKS