WRS3R3EW4 Westinghouse Refrigerator - Instructions

Took off bolts on top hinge , lifted the door off lower hinge With a srew driver was able to remove an replace both parts .
The doors is as good as new :0)

It was very easy to install. Simply removed the top plate on the fridge door. It was one screw. then removed the door and replaced the plate and bearing. The plate needed to be screwed in. Placed the door back on and replaced the top plate. Done! Easy and fast.

Removed lower cardboard cover, shut off water supply valve, unpluged frig. Used wrench to remove 3/8 water line from water valve, removed electrical connectors from solenoids, used fingers to unscrew water connections from valve.

The part was perfect. Did it on a Saturday night is about 3 minutes. Wa the total fix.

took the back off refridgerator, disconnected water valve assembly, then disconnected water lines and electrcal connectors. also i received the part in less than 24 hours

Punch out center of old support, then pull it out. Insert new suppport, insert center and tap flat with hammer. All done!

I unplugged the refrigerator. I then removed the two screws that hold the element in place. I then removed 3 screws. After that, I removed 3 screws that were holding the dispenser in place. I took out the old part and put in the new. I then put back all of the screws.

with helper to remove door and lay flat to remove bearing with needle nose pliers. Popped out old and installed New one by pushing in. Reinstalled door and tightened small screws making sure door aligned properly. Replaced Door Bin.

Pried the broken support insert out with a screw driver and pulled it out with pliers, then inserted the new and pressed it in and Presto the drawer now works good again.

1) Empty the refrigerator door (Good time to clean it too!)2)Take the cover plate off the top hinge. 3)Remove the two screws on the top hinge (Keep the door closed) 4) Oppen the door and lift up. It will lift out of the lower hinge. 5) Remove the screw from the door close plate and replace. 6)The door closure bearing is in a hole on the lower part of the door and is likely cracked in two. Remove the upper part from the door. You may have to remove the plate. 7) Replace the plate if needed and insert the new door bearing in the hole. It only fits one way due to the shape. 8) Complete steps 6 through 1 in reverse order. The whole thing takes 15 minutes. One person can do it. The door is very light.

Removed screw from upper plastic bearing cover, removed cover by sliding forward. Removed two screws that retained the upper bearing plate, pushing refrigerator door against refrigerator so as not to fall, slid upper bearing plate up and off. Lifted refrigerator door upward and away from refrigerator. Removed screw retaining lower bearing plate and had to remove door closing bearing from door by breaking with screw driver as part of bearing was broken and remained in the door. Re-installed new parts and re-assembled. Door works great and all parts fit perfectly.

Simple, I had a repair man come over and diagnose the problem. After confirming, I ordered the part and replaced it. Need to make sure you get the ice build up out of the fitting tnat goes from the back of the fridge connection at the top and the filler tube inside the unit, mine was iced over. Repair man wanted to charge me $250.00... with his service call and buying the part, it cost $120

I first removed the hinge cover at the top of the door. This allows the door to be lifted off of the bottom hinge. After removing the remnants of the broken part, I slipped the new door closure bearing in place. I reinstalled the door by sliding the door over the lower and upper hinges. Be careful to note that an additional part "door closure" may be necessary as in my case this was all one unit in the broken one.

all above

I read other comments and most suggested the fix is less than five minutes and a couple tricks (push the remaining piece into the frig if you can't pull out with pliers)and I did exactly that. Parts came in 2 days, repair took 5 minutes - it took longer to open the package. My wife thinks I'm a star!