WRS26MF5AQQ Crosley Refrigerator - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Push-down lever on ice actuator broke off
(1) Pull out drip tray. (2) Remove three screws holding in front panel. Pull out panel. (3) Unplug wiring harness and lay front panel aside. (4) Remove three screws holding in a long, narrow circuit board. (5) Unplug wiring harness at left end of board. (6) Pull unit forward so you can see the ice actuator. Loosen (do not remove) screws holding small metal plates where ice actuator pivots. Move left plate (single screw) out of way and remove actuator. (7) Insert new actuator. Be careful that gear on right side meshes with gear on black rubber door that holds ice in. (8) Reverse process to reinstall parts.
Parts Used:
-
Darrell from Helena, MT
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Refrigarator & freezer were not working
We took out the air damper and replaced the control with the one we purchased. It would probably work easier but it works and it saved us a lot of money not having to hire someone to come out and replace it. The refrigerator should be a little cooler but is within range therefore we hope it continues to be ok.
Parts Used:
-
Shayne from Osteen, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Everything in the refrigerator side was freezing.
The defrost thermostat kit is located in the freezer side of the refrigertor. I turned off the electrical breaker for the refrigerator. I began the project by removing all the frozen food on the lower half of the freezer. I removed the racks and 3 rails on both sides using a cordless drill with a 1/4" socket and located panel. The panel had 4 1/4" screws holding it to the back of the freezer. I removed all screws and the panel came out easy. I located the defrost thermostat and with some wire cutters, I cut the wires. I connected the the new defrost thermostat with wire connectors and reattached it to the copper tube I removed it from. I put the panel back on along with the side rails and racks.. This project was very easy.
Parts Used:
-
Efrain from Union City, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver
Was this instruction helpful to you?
Thank you for voting!
loud noise fan blade broke,off balance
take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .
Parts Used:
-
EDWIN from ELWOOD, IN
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver
Was this instruction helpful to you?
Thank you for voting!
We just needed extra door shelf that wasn't included with the refrigerator.
Part Select's website is really user friendly and has all the info you need to determine which item you actually want. I ordered on Friday afternoon and received the part on Saturday without having to pay rush shipping. Wow! Now that's service!
Parts Used:
-
Teresa from Rossville, GA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
icemaker would not dispence ice
-
Anna from Pittsburgh, PA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
shelf had broken and one was missing as we just moved into a new home.
Just popped the bin onto the door. Super easy. What's even better is that I ordered it late afternoon and had it the next day. Super fast service! I will do all my business here in the future.
Parts Used:
-
Tiffany from Middletown, OH
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
The Bottom Shelf Of The Refrigerator Door Was Broken
-
LESLIE from CORDOVA, TN
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
broken door bins
It was very easy, just slide the bins into the designated slots.
Parts Used:
-
Melissa from San Antonio, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Broken Bin
-
Steven E. from Fullerton, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
crisper supports were broken
I watched the do it yourself video which helped tremendously. My husband was busy so I was able to do it myself.
Parts Used:
-
Catherine from Richland Center, WI
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
door shelf bins were cracked
Ordered the door shelf bins. They were delivered in about 2 days. They fit perfect. Happy with purchase.
Parts Used:
-
Caroline from Columbia, TN
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
No Ice
I changed the valve but still no ice, changed the filter also. think it was just froze. could have saved me 70 bucks
Parts Used:
-
Glen from Black River Falls, WI
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Pliers
Was this instruction helpful to you?
Thank you for voting!
2 broken door bins
I ordered the parts, they came quickly by Fed Ex and I snapped the bins in place, took less than 2 mins.
Parts Used:
-
Judy from Goldsboro, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Ice Maker/Water Solenoid Valve Assembly
Purchased a replacement part only to find the new part had push on fitting and my part has screw on fittings. Went to Youtube where Partselect had a video on how to replace the part from screw fittings to push on fittings
Parts Used:
-
Kenny Keith from Terra Haute, IN
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Wrench (Adjustable)
Was this instruction helpful to you?
Thank you for voting!