All Installation Instructions for Tappan Range TGO356BCWC

Broken Drawer Glides

Just like the helpful Video. Thanks.

Parts Used:

Rear Drawer Glide

Front Drawer Glide

Rob from Ballwin, MO
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Igniter was past-due for a change-out!

Just opened up the oven and went to work. Really easy repair. Removed floor of oven with two thumb screws. Removed flame diverter plate from burner with one screw. Removed igniter with two screws. Marked top wire, then untwisted old wire nuts to remove the old igniter. Replaced with new igniter and used enclosed new wire nuts. Reassembly was simply the reverse of above. Only issue - I needed longer arms to comfortably reach back into the oven!

Parts Used:

Flat Style Oven Igniter

Kevin P. from Chanute, KS
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Wrench (Adjustable)

Was this instruction helpful to you?

Thank you for voting!

Front glider ( plastic) on bottom oven drawer was proken.

I took the new plastic glider out of the bag and it took me about 2 minutes to fix the drawer!!! EASY!!!!! Thanks. carol

Parts Used:

Front Drawer Glide

CAROL from salt Lake City, UT
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

oven not heating

Oven ignitor glowing but no flame . Tested ignitor w/ ohm meter reading 2.5ohms , should be 3.3 or higher to allow gas flow . Ordered new ignitor , replaces and jackpot !! Oven now fires and heats like new . Thanks for part . Cost , $50 instead of $150 .

Parts Used:

Flat Style Oven Igniter

Mickey A from Linden, MI
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers

Was this instruction helpful to you?

Thank you for voting!

The Ignitor had a brunt spot in the center.

I use a 1/4 in. socket and and ratchet to remove 2 screws and removed cover to get to sheild to unplug the two wire plug . Then used needle nose to remove two conectors from the gas valve.

Parts Used:

Flat Style Oven Igniter

Homer from Dayton, OH
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Socket set

Was this instruction helpful to you?

Thank you for voting!

Would not light.

Removed oven racks. Removed oven bottom and flame diverter. removed two screws and cut wires. Spliced new wires and reassembled.

Parts Used:

Flat Style Oven Igniter

John from Munster, IN
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Stove would not ignite on rf burner, sometimes when jiggling knob it would lite

Unplugged appliance,Removed all knobs,they pull off,removed front panel that the knobs protrude thru, 1screw right.End and left end, 2screws going downward thru burner assy, 2screws from oven opening ,,accessible with oven door open,,, slid igniter off of gas valve, disconnected wires from old igniter ,slid new igniter into same spot, reconnected wires,reinstalled frt panel,, plug it in,,, done

Parts Used: