434227-1-M-Frigidaire-3051163-Rear-Drawer-Glide.jpg
434227-1-S-Frigidaire-3051163-Rear-Drawer-Glide.jpg 434227-2-S-Frigidaire-3051163-Rear-Drawer-Glide.jpg 434227-3-S-Frigidaire-3051163-Rear-Drawer-Glide.jpg

Rear Drawer Glide

PartSelect Number PS434227

Sold individually.

This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.

This part fixes the following symptoms:

  • Door won’t close.
  • Compare At

    $4.99
  • You Save

    $.83
  • Your Price

    $4.16
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Videos For installing this part.

Related Parts Additional or alternate parts to consider.

Part PhotoPart DescriptionPriceAvailability

Front Drawer Glide

Part Number 434226

Sold individually.

$3.71
In Stock

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.7 / 5.0, 46 reviews What's this?
1-15 of 46
 

311 of 313 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:1- 2 hours

ToolsPliers, Screw drivers

CustomerSteven from Taylors SC

Rental property stove only had 2 working burners and bottom drawer off track

first i took out burners then i took out the screws of the termnal block bracket. i then raised the lid on the stoveand clipped the wires on all 4 of the terminal block kits.i then slipped the shrink wrap on wires and used the wire nuts to connect wires together then heated the shrink wrap. I then put screws back in terminal block brackets. I then put the burners on while looking under lid so i would know they were making good connections as this is a bad design from factory. if you pull out burners to clean them and they are not put back in right you dont have a good connection and that causes the terminal blocks to get hot and melt. thats what happened in my case.
As far as the drawer glides they just snap into place

Help other customers find the most helpful instructions.

Were these instructions helpful?

137 of 259 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerMichael from Middleton NH

Bottom drawer broken

Frst I slid the drawer out.I then pryed the broken drawer glides off with a flat blade screwdriver. The new drawer glides then just snap into place,then reinstall the drawer and check for smooth operation.

Help other customers find the most helpful instructions.

Were these instructions helpful?

67 of 68 people found this instruction helpful

Parts Used

  • Rear Drawer Glide

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

Customerjennifer from La Habra CA

Drawer was tilting and wouldn't slide open easily.

The old glides were broken off so I didn't know I needed these glides until I saw the parts section of the Manuel. When they arrived I snapped them in with no effort at all.
P.S. The shipping is fantastic here......i ordered on Monday received them on Tuesday. Now that's shipping:>)

Help other customers find the most helpful instructions.

Were these instructions helpful?

92 of 155 people found this instruction helpful

Parts Used

  • Rear Drawer Glide

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerScott from Noblesville IN

Replacing broken parts

The two back door glides were missing and broken (one of each), and needed to be replaced. Finding the parts online was MUCH easier than I expected,and the repair was remarkably simple. Parts snapped into place, the drawer had to be lined up, and it slid right into place. Very easy!

Help other customers find the most helpful instructions.

Were these instructions helpful?

71 of 138 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsNutdriver, Screw drivers

CustomerGary from Cloverdale IN

Oven would not shut off

I simply removed 6 screws holding the back cover removed 4 wires from the old clock removed the 4 screws holding the clock. set new clock in place put the 4 screws back in reattaced 4 wires replaced the cover.

Help other customers find the most helpful instructions.

Were these instructions helpful?

5 of 6 people found this instruction helpful

Parts Used

  • Rear Drawer Glide

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerKathleen from fall river MA

Draw glide broken off bottom drawer.

New part arrived, opened pkg., pulled drawer out...snapped in new parts....DONE!! Saved myself $100.00.

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 4 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerMichael from Signal Hill CA

Broken door glide

snapped the new piece of plastic in its place and ta da, its fixed.

Help other customers find the most helpful instructions.

Were these instructions helpful?

5 of 9 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerRosemarie from Anchorage AK

Trim handles broken during moving

Used a paint spatula to pop upwards the old bottom half of the door handle trim, has metal inserts inbetween pieces.
Snapped new ones on.
Was initially intimidated, but only took 5 minutes to replace both.

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 8 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsNutdriver, Screw drivers

CustomerMichael from Anchorage AK

Overlay was cracked, drawer glide missing

Overlay replacement is easy; 1st remove two screws that hold panel to top of stove (philips screwdriver) and lift up off of lip at very top, 2nd remove two screws that hold control to panel (nutdriver or square drive screwdriver), 3rd peel old overlay from control panel face (make sure you get any & all little bits so new overlay sits flush), 4th peel backing from overlay and position over control panel (peel protective film from face of overlay as well), 5th reposition control panel and reinstall two screws removed in step two above, lastly reposition top panel on stove and reinstall the two screws removed in step one above.
Drawer glide just snaps into place on the lower rear corners of drawer, then you slide drawer back into place.

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 2 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerRON from spokane WA

Used knobs from hardware store wore out fast

I just popped in the glider part to the oven drawer worked perfect. put new knobs on range my wife stated makes our old range look like new we thank you for the parts we were not able to find any where else

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 1 people found this instruction helpful

Parts Used

  • Rear Drawer Glide

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsPliers

CustomerFred from Ocala FL

Originaldrawer guide was cruched out of useable shape

first thing was to remove the crushed guide with pliers and a twist it was out. to install the new one islipped one side into the slot and took pliers and applied pressure on the lower glide into the slot; it was done presto. works like new. thanks,
Fred . it was so reasonable i got a spare.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 1 people found this instruction helpful

Parts Used

  • Rear Drawer Glide

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerHoward from Poteau OK

Oven drawer would not open or shut completely

first I emptied the contents of the drawer,then pulled drawer open to it's fullest, then lifted drawer so as to tilt slightly, then removed drawer by continuing to pull straight out. then I removed the glide from its protective packaging and inserted it in the same spot as the broken glide was at one time

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 1 people found this instruction helpful

Parts Used

  • Rear Drawer Glide

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerFred from Gregory MI

The right drawer glide was broken.

The simplest repair ever! I just snapped it in and put the drawer back - fixed. I hope I have other repairs this simple.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 1 people found this instruction helpful

Parts Used

  • Rear Drawer Glide

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerSharon from Hamlin NY

Broken drawer glide

IT SNAPPED RIGHT INTO THE DRAWER, WAS VERY EASY

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 2 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

Customerbryan from sparta WI

Drawer glides were broke on front and back

used a screwdriver pushed the old ones out put the new in. the video instructions were great.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-15 of 46