PSS25SGNABS General Electric Refrigerator - Instructions

Not a clue on what I was doing. I watched the video this company sent me on how to remove and install the auger. This video came with my email confirming my package was sent. I watched this video as I installed pausing it until my task was completed and it was done in no time.

Replaced Water Filter (twist off old filter; twist on new.)

I followed instructions from a video. I pulled off the front panel, then the circuit board unit. Next I removed the Solenoid Assembly and installed the new one. I replaced everything and tested the water dispenser with no success. I assume the solenoid assembly was ok so therefore I need to get the circuit board tested.

We watched video, had new flap spring ready and collected tools for job. The Suggested putty knife to remove plastic frame on door did NOT work; Video was Wrong for our Model refrig - There are NO tabs inserted into refrig door, the Frame is fastened by hex screws from the inside the door/ ice troth, which would have entailed us to remove inside rubber door seal, plastic liner, insulation and who knows what else ? maybe wiring. We choose to gently pry off and break the screwed inset channels...... After removing the frame it became EASY, just followed the video details, taking selector facing off, unhooking the wiring, unscrewing wiring panel and removing the flap..... We inspected the solenoid for rust, cleaned it off then installed the new spring on flap lever. Easy Put everything back in place and covered the frame area with metal tape till a new frame arrives.

followed part select video instructions

Used small screw driver to pry the top of the switch away from left inside wall of freezer side of side-by-side refrig./freezer; then used pliers to remove the switch; then removed the 3 prong socket and plugged it to new switch and installed it into the inside wall of the freezer.

Followed instructions and it was very easy

followed video

I bought the complete kit. pulled the old one out and pushed the new one in. No problem at all.

Solenoid pushing the crushed ice flapper was burned out. Solenoid was easy to find unplug and replace. I used the old piston which simplified things. Now works great

the parts I ordered did not fix the problem the problem was with repairman did not follow the instruction and cut jumper wire on main control board

A very simple install. Requires the removal of 4 screws and plugging in new heating element refer to the excellent diagrams provided on line

The repair was extremely easy because PartSelect.com had a video on how to repair this item. I set up my ipad and played the video step by step. The gentleman, who was explaining how to replace the part, was outstanding! He did not miss one step which made my repair very easy. It took less than 30 minutes from getting my tools, replacing the part, re-installing the ice bin, and clean up. The only prep work was, in the morning, I removed the ice bin so it could be room temperature, just like the video said. (I saved the ice so my family could have ice throughout the day.)

Unplugged power cord, removed back panel, disconnected wires, removed existing control board, installed new control board, reconnected wires, replaced back panel, plugged in power cord. The video instructions made it really easy. Saved at least $100.00 doing it myself. Awesome!

I followed the instructions under "Plastic auger blades broke in ice tray". The only difficulty was getting the part 325 to release from part 352. Had to do some careful prying with small flat screwdrivers to make the release.