PHS69EHSS3 Frigidaire Refrigerator - Instructions

just put it in the old hole. the hard part was getting the old one out. you have to poke the center piece in to remove. otherwise you will break your fridge. then you have to to pull the center piece out before you put new in.

husband did it took only a few min part was easy to find

Unscrewed the top hinge, lifted door and laid it down. Took off old hinge bearing and snapped new one in. Put door back and no more noise. Easy fix. Only problem was that I couldn't believe I waited so long to fix that simple problem.

Easy to assemble after cutting original water line fittings off. Use sharp knife to keep from damaging end of water lines.

removed old air damper, installed new one. one nut driver, 5 screws. replacement had motor and switch included. $80 delivered ups 1 day.

take of the tray & take parts out & installed the new ones

Popped the old water filter out and popped the new one in, just as easy as that!!

I took the ice drawer out, unwrapped the new one, push it in and that was all I did. It works like a charm.. I'm 80 years old. So any one can do it.

Pulled the old filter out and pushed the new filter in.

Installed the ribbon on the face plate first and then to the main part of the door. This prevented the wires within the ribbon not to be broken. then put the cover on and screwed it in.

The two screws that held the ice maker in place could not be seen do to there location. I could only get one hand inside do to space restriction.So I placed a mirror inside so I could see the screw heads and from point it was very easy to see and line up the nut driver on the screw heads. I then lifted it up and unplugged the wiring and installed the new ice maker. Works like a charm. Paul

Slid the new bins right into place. Very simple fix.

followed the video instructions and wa-la! Saved my money by not calling the repair man, the shipment of my part was fast, and the repair was even faster. Thank you for helping me in my repairs. Very Satisfied!!! Carol

slede it in place

This was probably the easiest repair I have done on this refrigerator. I pulled the unit away from the wall, turned off the water, and disconnected the hose. I have a wooden floor in my kitchen so I was careful to put a towel under the hose and valve. Very little water drained out but I kept the towel there for insurance. After removing the access panel, I removed the two screws holding the valve in place, slid it back to where I could unplug the wiring connected to it. The connectors are color coded so there is no worry about putting them back incorrectly. The new valve uses push-in type water connections, so you have to cut the old style connections off of the plastic water lines. Kitchen shears did this easily. Then is was just a matter of pushing each line into the proper connector on the valve, reattach the electrical connectors, and slide the valve back in place. Reinstall the screws, reinstall the access panel, hook up the water hose, slide the unit back into it's niche, and run about a gallon of water through the dispenser and you are done.