MSD2542VEB00 Maytag Refrigerator - Instructions

unplug refridgerator; remove freezer shelf above ice maker by popping front edge up and sliding back; disconnect power plug from bottom front of ice maker; remove three screws holding old ice maker (two above and one below); remove power extension adapter that was not needed from new ice maker; move wire on/off lever from old icemaker and install into new ice maker; insert new ice maker by threading water inlet tube through ring in back of new ice maker and secure with three screws; plug power plug into new ice maker and plug refridgerator back in

I replaced the relay started right up did fine for about 4 days. Came home from work I had lost everything in the freezer again.turned down the thermostat and back up and it started right up. 5 days later same thing again.

I found exact instructions on Youtube. Watched the video. Verified that my Control Bracket was in fact broken by partial disassembly. Ordered the part from PartSeclect. Received the part the next day (though I only paid for ground/standard delivery). Installed the part as described in the video using only two screwdrivers and needlenosed pliers within 14 minutes from start to dispensing water again. My water dispensing was interrupted less than 48 hours. Amazing!!! Thank you. It was fun, fun, fun.PaPa43

Removed and replaced retaining clip and installed a new strain relief. Parts arrived in 2 days from the time they were ordered. No problems whats-so-ever. Great doing business with Parts Select again.

Order at 2:30 PM on Tuesday and had it by 1:30PM Wednesday. Less than a day on the delivery order. Thanks!

removed old parts from bin and installed new bin

Removed outer cover. Removed control bracket which holds the water/ice dispenser paddles. Removed paddles from old/broken bracket, plastic pins were broken where the paddles hinge. Placed on new bracket placed screws and it was done. Very simple repair. Part cost less then $18.00 including shipping. Saved me mucho dollars!!!!

Remove rear panel with 1/4 nut driver. Pop plastic cover on compressor. Pry off relay and two wires and reinstall. Nice and easy and back to full function :)

hardest part getting the putty knife in right place to pop off cover---found the plastic bracket was broken where the switch was held in place---- so ordered new switches and bracket ---- got the parts in 3 days--good service--easy job 2 do and saved lots of $$$$$$$$---

I absolutely could not believe that the 2 bins we ordered arrived the 2nd day after I ordered them when I just used ground service! So nice to have usable bins again...and they snapped right in. Thanks for your prompt service.

With service sheet, Enter service dagnostic mode, NO-6 is Desrost heater / Bi-metal Component status indicator shows 02 , it means Bi-metal is open, It should read 01,It's cover with Ice ( bellow 32 Dig. F )Mostly it open at 50 dig. F, To replace remove lamp cover and lamp + six hex screw with 1/4" nut driver, pull back cover ( with commen requirement to turn of power and deice the evaporator coil )out, bi-metal element is top at enterance of coil,cut both wire near bi-metal, join new bi-metal with wire nut or Insulated wire Jointer, Tape jonts proper,do neat work no hanging wire, Replace back removed parts back,Turn power back

Removal of the old heating element was really easy. The video on Partselect.com was majorly helpful in reassuring my confidence in doing this repair.

I watched your video and did just as he did. The video made it real easy and rather simple. It looked like it was going to be a mess until I watched the video.

empty frezzer take door off unplug wires going to ice maker unscrew/bolt icemaker replace door take motor cover off ice maker remove screws on motor replace ice cup and put every thing back together

unplug freg.took everything out.pulled out shelves and pulled out back panel.their was my part i had to replace.