KUDY25SHWH1 KitchenAid Dishwasher - Instructions

The dishwasher was making grinding noises and then stopped draining at all. I was able to follow the video directions and replace the parts from the drain and wash impeller kit, but it did not solve the problem. Must be the pump or something else. Was worth a try and partselect.com was good with service and price.

Found the water supply tube in the bottom of the dishwasher, decomposing and half-melted. Took a while to figure out what it was, where it came from. Found replacement parts I needed very quickly on this site. Removed existing hardware, installed new parts in their place. Quick and easy, all the way around.

I followed the directions of the repair video. It was almost right on. I had to use a needle nose plier to get the old shaft seal out of the bottom instead of a screw driver. And the video showed the wrong placement of the 2 check-balls in the bottom. They both sit together in the same pocket in my unit, not separated at each end of the water channel as in the video. The parts diagram is correct. Note that after doing this repair I ran 1 cycle of dishes then my water valve failed. So I had to replace that too. My machine now runs like new with all dishes coming out clean and sparkling.

replaced seal on door frame. Soaked in warm water to make more pliable. Identified center and worked from center down each side. Very easy.

Husband unscrewed the parts to replace. Simple! Thank goodness we still have my mother's dishwasher of about 16 years old!

Just followed your video and voila!! With an ailing husband and other expenses, You saved me at least 100.00 service call. Thank you parts select..

Watched a video online. Watching this video made me buy the parts. Very helpful. Unscrewed the spray arm, replaced the spray arm seal and wash arm bearing ring on the lower portion of the dishwasher. Removed the upper rack (per instructions on the video), unscrewed the upper spray ring and replaced the seal. Also cleaned the filter and removed debris from the spray arm. Dishwasher cleaning well again.

Followed the instructions in the online video at Parts Select website. Couldn't have been easier. Delivery service was also very prompt. I was very pleased.

The top ring was missing and new nuts kept breaking. New plastic ring on top did the trick.

Unscrewed the lower rotating wash arm. Removed old wash arm bearing. Set in new spray arm seal. Replaced rotating spray arm. Dishes are now cleaner.

I removed the old nut and the wash arm, cleaned the screen, clipped the plastic circle into the arm, placed it on top of the screw and screwed in the new nut. Works great, nice clean dishes, and......no noise at all. Did this all myself, and ordered the part from you. The old nut was stripped. I almost bought a new dishwasher.

Removed two screws, disassembled sprayer arm and mount, replaced with new units, replaced one screw and was finished.

if the top rack on your dishwasher is not coming out clean ......and you are looking for a solution...this is prop. it....easy....very easy.......upon taking a look at the fan under the rack i noticed it was cracked on the seam....the new one works perfect....easy to install....and this part showed up at my house within two days of ordering.....as far as it goes easiest home project ever.

Replaced broken arm holder using screwdriver

I watched the video and went to work on the project. I did come to a moment when I thought the mount component was different on my system relative to the replacement, but one more quick look at a point in the video and I was ready to finish the job. By the way, it was good to see even the demonstrator had a wee bit of a struggle with the stop clips. :o)