JDS9860AAP Jenn-Air Range - Instructions

Instructions did not included need to pull oven from wall to access connections. A pro knew what to do, was finished in 10 min!

Pulled out broken element, took out screws, put in the new part and inserted it.. My son had to do it though. Easy for him

Take your time and remove items carefully and replace with new items. Very easy but you definately cant rush and possibly need new screws to make it even easier.

Super easy; pulled out broken element and pushed in new element. Wonerful service, communication, shipping. Received part in Seattle and mailed it to Hawaii installed without a hitch. Thank you

Followed provided video

Just followed the instructions in the video!! A repair service was going to charge $95.99 just to walk in the door!!I I just ordered the igniter part. Watched the video and I know I can do that too!! I have only had one self igniting burner for years - didn't want to pay for a service call. Love your company!! Thank you!

This is a no brainer. I am only doing this because you asked. Pull out the stove, tilt it back, remove broken leg, install new leg.

Unplugged the stove removed back cover plate unpluggeg two wires removed racks from oven removed two screws that hold bake element in place and reversed process

Just slipped the new knob on with no problem. Very easy.

Got a bent metal coathook to temporarily release the oven door, removed the screws from the old probe, inserted the new one, and hooked it up, using the one of the plug adapters provided. Problem solved! The oven door latch was now disengaged, the oven would now accept temperature inputs, and the rear cooling fan (which wouldn't shut off) now turned off. That's a lot of things working better for less than $50!

Read the ID number from label and ordered part on line. Part was delivered next day. Shut off power to stove and Pulled stove out from cabinet setting. Took out about 12 screws from back pannel and removed it. Pulled out wires (easily seen) from each side of heating unit at back of stove. Went inside oven and took out 1 screw (easily seen) on each side of heating element at back of oven. Heating elemnet came right out. Reversed procedure for installing. Only tool used is a small Phillips screw driver.

I have a Magic Chef gas stove, The top burner came off with ease, just a quarter turn then pull up to expose igniter. Only two wires to remove and two phillips head screws to remove to release igniter. I was done in 5 minutes.

The spark module pulses a stepped up voltage to all four burner sparks at the same time regardless of which burner you want to ignite. I read that this part lasts about 10 years. I don't cook much and it lasted 13 years. On my Magic Chef the part is behind the right side wall panel. Lift the range top,remove all the screws that hold the right side panel in place. This replacement can done without opening any gas fittings.

Removed old igniter set replaced with new one. Hardest part was using the screw driver to removing the backing. Saved us having to buy a new stove since we just bough the house.

Lots of small metal screws to remove on the housing, gas supply and electric igniters. The only challenge for me was getting the old burner heads out of the trays- they ere rusted up and needed a little penetrating oil and time to break free. I re-used my old igniters- had to bend open the little metal rod at the tip a half of a millimeter to get them to fit back thru the new heads. Keep track of how things come apart and the way the gas lines assemble and it's an easy project. Be careful not to over-tighten old screws in rusty holes in the trays.