JDB8910AWS Jenn-Air Dishwasher - Instructions

I ordered the basket on Sunday and received it on Tuesday. It is a better basket than what originally came with the dishwasher. Very happy with the prompt delivery and service.

Both the handle and the screws that attach it to the dishwasher door had broken off. To replace the handle, unscrew all the screws holding the inside steel liner to the door. This takes a very small screwdriver or a screwdirver with a small star-shaped end. Do not pop the vent on the inside of the door. If you do, you will have to whack it hard to get it to seal again. With the screws broken off, you have to guess the replacement length. It worked with 1" #8. I think the thread count is 10/inch. Most of the time involved was finding the right tools, getting the right screws and replacing the vent, which I should not have removed in the first place.

Extremely easy to repair. I can't believe I didn't do this earlier.

I Googled parts for an Electrolux wheel and Parts Select came out with a picture that confirms the one that I need. The price of the item was very reasonable as compared to the official website of the manufacturer. I like what I saw and bougt 4pcs instead. I will recommend Part Select to my friends without hesitation.

replaced mounting strip and two wheels

I found a short video on YouTube that showed me how easy it was to remove the old dishrack and install the new one. I would have never figured out how to get old diskrack out without watching short video clip. And, all I needed was my fingers to undo the end clips.

I took the suggestion of a previous reviewer to bend the new part in. But instead of using pliers to remove the old part, I tried bending it to get it out. This was so that I could see how much force would be necessary to bend it without breaking it to get the new part in. I bent it in the middle and was able to get it unhooked from one side without too much force. To get the new piece in, first I made sure I had it lined up correctly. Then I inserted the circle over one of the side prongs to hold it and gently but firmly bent the piece in the middle until the circle on the other side could slip over the other prong. It was not bent enough to stay bent, just to compress it into the space and have it spring back to full length.

Once I identified the model number it was really easy to spot the right part numbers I needed for my repair, the ordering system was easy and in a few hours a I got my order shipment information, the service was absolutely superb, the parts snapped in without problem and in a few minutes I got my dishwasher back in good operating condition.

I removed the old pieces and snapped the new ones into place. For one part I watched the online tutorial to make sure that I did the replacement correctly. It was all very easy. The delivery and installation took less than 24 hours. I couldn't have gotten a repairman that quickly.

remove panel on front to acess float @ float switch.Remove phillips screw to float switch,remove palnut from float shaft with 5/16 nutdriver.Remove float from inside washer.Reinstall new parts reverse order.

Followed the outstanding video instructions. Your company is fantastic. Your attention to detail, the quick shipment (one day) and video ... stellar! We will be referring your company to all!!! Thank you!!!!

I took the old one out of the dishwasher and put the new one in. The new one is much nicer and heavier than the original one!

Snapped in the new ones in a skinny minute. Just make sure you leave the old ones in the dishwasher rack until the new ones come in it can be confusing if they are removed. My wife took them out so I had to figure out how they went back in but was not a big issue. I did have to swap ends to make it right but less than fifteen minutes and like new again.

took inside front off disconnect wires pull old unit out and put new unit in then put inside front back on tighten screws was done unit works like a new machine

Watched the video ordered the part. It was delivered the following morning. Un screwed the spray arm holder put the spray arm and retainer in the holder then screwed the holder back in the dishwasher.