| |
4 of 4 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:15 - 30 mins
Tools
CustomerPeter from Andover MA
Rusty movable shelf racks
Since there are no nuts or anything else to remove on these racks, bending them into place is the only obvious way to go to fit them onto the existing racks. Taking out the old movable racks is the easy part - just take a pair of pliers and bend back the 'O' part of the movable rack where it goes over the pin on the big rack. To put on the replacement racks, I found that I had to bow the racks in the middle to make them fit. Simply pressuring them into place didn't have enough give. With a helper to hold the big rack steady, I could use 2 hand to bow and align the movable racks and snap them into place. You have to be careful not to bow to much or you could permanently bend the new parts. I broke one weld between the short pieces that go perpendicular to the long wires on the new rack by putting too much pressure on the long wires.
|
3 of 6 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerThomas from Centennial CO
Old shelf rack and silverware basket (yellowed & stained)
Removed the old dishrack shelf by taking off the end caps. A screw driver was used to release the plastic end caps. The old dishrack shelf is now able to just roll out and the new shelf is rolled in and the old end caps replaced. Quick and easy plus it makes the dish machine look new. The new silverware basket requires no tools just replace the old one.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerJoel from New Rochelle NY
Replacing 2 parts, one of which had broken, needed replacing
Both parts were easily replaced without the use of any tools. Just slipped into place.
|
0 of 2 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerDaniel from San Diego CA
Shelf/rack rusting out
Remove end stop. Slid rack from track. Replaced with new rack. Re-installed end stop.
|