HSS25IFMBWW Hotpoint Refrigerator - Instructions

unplugged refrigerator to defrost ice on coils, removed shelves and ice bin and then began to un screw back panel which was a combination of hex head and Phillips head screws, two more screws to undue the heater element and unplug two wires on each side of element noting which color was on each side installed new heater element in reverse order.

Followed the instructions. Smooth as silk. This part is better than the original. There appears to be a sensor that beeps when the ice reservoir is full.

Part came in on time, and the repair went smoothly - no problems

I followed the instructions on the youtube video on the company web page. I removed the cover by hand, removed the exisitng flapper door and install the new door, easy as pie.

Located temperature sensor on condenser in the freezer section( as per instructional video ). Cut off bad sensor with wire cutter then soldered on the new sensor and sealed with electrical shrink wrap.

Took the paper clip, pressed in through the holes on the bottom of the ice dispenser panel. Removed the four screws. Loosened the panel and removed the wires. replaced the flapper door. Then reversed the process. Your video was VERY helpful except for the paper clip. Had to get that off another web site.

Replaced the piece that I thought was bad but discovered it was not the part that needed to be replaced. Lesson learned is take the ice bucket apart to be sure what part is bad and needs replacing.

Removed the old broken one with screw driver and installed new one with screw driver and voila all done!

Well, the first time I tried to pry the door trim piece off and noticed after breaking it that it was screwed on from the back. So I removed all 36 (or so) screws and removed the whole inside door panel and the ice maker. I got it all taken apart and replaced all the parts. put it back together....and it still did the same thing, the door still didn't close. I had replaced the solenoid, door, spring and recess crank. So I looked on this site again and read about the little holes on the bottom of the control panel. I pushed up into those holes and the control panel came off. Then, after removing the wires, I removed the four screws in the ice maker and it exposed the area I needed to work on. No problem, easy access and checked and operated the ice maker while it was apart. It worked perfectly, so I put everything back together and it's worked ever since. This site has saved me a BUNCH of money in repairs....THANKS!!!!!

repair went great, snap out snap in, less then 2min

Not only was your parts selection very easy to understand,
The Video shows exactly how to install that part.
This was So Easy to repair. I thought I would have to take
the door apart from the inside but the repair was completed
with the door closed and took about 10 to 15 min. to complete.

After identifying a likely solution using other stories on this site, I ordered the replacement valve. Very easy to repair. Just move fridge, unscrew cover in lower rear and change out part located right behind cover. I decided to change the filter at the same time because I didn't know the last time it was done. It could probably be done in 5 minutes, but if your like me you clean everything while its apart.

Your video on replacing the solenoid and ice flapper were perfect. Thanks again.

After watching the video it took me about two minutes to change out the valve!

as per video- follow all of the videos and u r going to save a lot of money tx partselect im glad I found u guys ps only order from partselect.com they only ship the correct parts remember look at the video select the symptom and buy as per video tx again problemsolved