HDA3700G00WW Hotpoint Dishwasher - Instructions

While the delivery was swift, the new lower dishwasher rack wheels were narrower than the originals. The rack would fall into the lower area and not roll out easily on the channel. I removed the wide wheels from the old rack and exchanged on the new one. It took some brute hand strength but worked. Still not perfect, but better than rusted lower rack.

taking off the little front brackets, was a little difficult. I had to have my husband do it, but it was fine and it works great now,

Place the axle inside the wheel. Mount the wheel to the bottom of the dish rack and snap the axle to secure the wheel to the dish rack. Total project time less than 5 min. Video to replace wheel and axle was very helpful for those who are not mechanically inclined.

Researched problems on internet,based on info ordered part. Got it in 24 hrs.followed package directions. So easy and for less than a service call! Runs like a charm now.

Remove rail end pieces installed the clods on the side rails and basket put end pieces back in place. Ready for washing dishes

No repair; just replacement. Delivery was very fast.

No repairs needed, just replace the lower dishrack with 2 broken wheels with the new dishrack with the wheels already attached. Easy as A,BC or 1,2,3.

Followed the enclosed directions and the video helped a lot. My model needed a different motor mount bar than in the video but wasn't hard to figure out. From shutoff of the water, unplugging, and undoing the screws under the counter and pulling the old pump/motor and installing the new pump/motor and putting it all back took a leisurely 90 minutes. Be sure to hang onto the old plastic covers for the electric leads to reuse.

Check website, order part. Hardest part was determining which was the right part. Needed the axle--I call it the hanger. I had previously called and ordered, but only received the wheel with no way to attach it. Push the axle into the wheel. Push the axle onto the rack. Since it was new, it didn't slip right on, and had to push it hard. (However, when it snapped on, three of the other wheels and axles came off.) Had to put them back on as well. Much easier, as they were older and not as snug. Total time: Took longer to open the package than put it on.

I popped out the stoppers at the end of the gliders. removed broken rollers and slid on new rollers.re-installed stoppers, tested all functions. tested good

Pop out the old baffles with the help of a screwdriver, push in the new parts in their places and done.

We watched the video describing the replacement process, cleaned the groove after removing the old gaskets, and installed the new gaskets as sown in the video. The installation passed the test washing a full load after the job.