GZ2626GEKB13 Maytag Refrigerator - Instructions

Changed the ice and Water filter, works great...

Just popped it out with a screwdriver, pluged in the two wires and popped the new one in. Took 2 minutes.

Removed 6 screws total and removed the entire Auger and Ice Crusher. The broken Helix just fell off, I put the new one on after a little finagaling to get it lined up right and it just snap into place. Replace the screws, put the bucket back, dumped in the Ice and the dispenser started working Fine.

Remove ice tray from freeze. Removed all screws, replaced wheel. Reassembled unit.

I popped out the old switch with a screwdriver pressing down the tab on the bottom and unplugged the terminals. Then I plugged in the new switch and popped back into the socket. Piece of cake!

There was three screws to remove to unmout the ice maker, and unplug the wire harness,then two to remove to slip in new stripper. All took about 20 mins.

Repair was tremendously easy. All I did was remove old light switch by prying out with screw driver and plugging in the new light switch and pushing it into the hole. Simple! The instructions weren't needed, but they were very thorough.

Ordered from P S and very fast service customer service was great. I would recomend P S to anyone that needs parts.

removed the old part and replaced with new. Part came very quickly....

Had to push the light switch to get lamp to light up.
Removed power from refrig. and removed old light switch
and replaced with the one I got from Partselect. Turned power back on and was done.

followthe instructions in the book that came with the refrigerator

very easy, with use of screwdriver and 1/4 in nut driver. just remember the way the blades go and get them back the same way. had it fixed in 15 mins.

I removed the ice tray and removed the front plastic cover that simply snapped off. I removed 4 hex screws with 1/4" nut driver. Then pulled the auger forward. This allowed me to slide the end cap into place. I put the auger in place and retightened the 4 hex screws, snapped on the plastic cover it worked fine

The first step in making any repair is finding the right replacement part. It took me about 5 minutes in the internet to locate the correct part at PartSelect. Another 5 minutes to order the correct part and receive a confirming email. Replacement installation of the defective part was 5 minutes to install the new part and verify that the problem was solved. The under-the-counter lighting worked once again which made my wife happy, which as you know make everybody's life better.
Thanks for the fast shipping.

1. Removed ice maker from frig.
2. Emptied all ice cubes.
3. Let it warm up to room temperature.
4. Removed front cover from bottom up (unsnapped).
5. Removed 4 screws.
6. Removed old helix cap.
7. Installed new helix cap.
8. Reverse of step 5 to step 1 above.