GSD6660G00SS General Electric Dishwasher - Instructions

First I removed the 8 screws on the interior side of the door that holds the plastic inner-face to the door assembly. This allowed me to easily pry the inner face away from the outer face which exposed the latch assembly.

The broken latch practically fell out making it very easy to work the new one into place.

I replaced the 8 screws, closed the door until I heard it latch and then squeezed the handle and was rewarded with a very satisfying sound and feel as the door popped open without a hitch.

I know a repairman would have cost me a minimum of $75 plus a hefty price for the part.

I removed six screws and unplugged the module and removed.
Replaced by the new module and plugged in and then replaced the six screws.
Very easy to fix.

Popped in the part

I removed the face plate (ice/water, selection panel) from the freezer door to access and remove the solenoid which was badly rusted and replaced with a new one, and a new spring too. Very simple repair for a chronic pain.

first i see if i could move the metal piece it wouldn't move si i used a flat head screw drive to fix it . the end piece was to long so i cut a piece off it fitting it is not moving

i needed new rollers and inserts to keep wheels on now its like new when i pull out bottom basket

so easy! Ordered the rollers and clips ... popped them on and done!!!

I had a slow leak from vicinity of sump. I replaced sump and pump connector as these were only likely sources of leak based on parts select history. Turns out plastic tub had a fine crack. The crack was directly under the heating element which had melted the plastic and over time created this small crack that was found by a repair guy immediately. I even suspected a tub leak and searched for one but being directly under the element made it invisible to me and in an area I did not suspect (front). Oh well - also learned GE charges $100. to come to my house, show me a crack, and leave (I repaired it with epoxy).

just snapped the new part in. couldn't have been easier

hubby had no prob replacing the new part!!YEA!!dishes are clean again!

Super easy..........just push it on and it should snap in place. No tools required!

Remove bottom articulating sprayer and water fittings. Remove and replace filter

I ordered both new wheels and stud that goes in the centers of each wheel. It took longer to cut the bags open than to install them. Works like a dream and no sqeaking and dishwasher works better since it is the correct distance from the water rotation arm on the bottom of the washer! Wonderful experience by an all thumbs do it yourselfer!

After finally getting the door open and opening it up, the problem became apparent. Partselect helped me locate the part. it came quickly, and the repair was simple. It took me two trys to discover how the spring fit, but once I looked closely at the diagram, it was a cinch. I was a very proud dishwasher owner!

Parts were easy to find, easy to order and arrived prior to the advertised delivery date. Instructions for replacement were easy to understand and in about 10 minutes the old part was removed, and the new one installed. thanks for your prompt and efficient company.