Models > GSD6660G00SS

GSD6660G00SS General Electric Dishwasher - Overview

Get Parts and Repair Help for GSD6660G00SS

If you know the dishwasher repair part you need, you can browse the list of all parts on the GSD6660G00SS, or you can search by name or part description. You can also find your part by where it is located on the GSD6660G00SS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for GSD6660G00SS parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$1.25

Single Lower Wheel Stud/Axle

Sold individually. This is just the axle that holds the wheel in place on the dishrack. The wheel is sold separately.

$1.48

Single Lower Rack Wheel

This wheel is located on the lower rack. It is sold individually and does NOT come with the attaching axle.

$0.64

RACK SLIDE END CAP

This part attaches to the rails, for the upper rack, to prevent the dishrack from sliding all the way out.

$1.21

Wheel Axle

This axle attaches the dishwasher wheel to the rack. Sold individually.

$2.57

Slide Roller

This is the wheel that is attached to your rack by an axle, which is sold separately, and slides within the rail on the side of the tub.

$2.91

Recess Door Spring

$43.36

Detergent Dispenser with Rinse Cap

$46.61

Water Inlet Valve

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed. This valve has a 3/8" inlet and comes with the mounting bracket.

$8.64

Door Handle Actuator

$4.27

White Track Roller Kit

This upper track roller kit comes with a screw for easy assembly.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Wheels missing or broken

  • Customer: MARIEANNE from WOODBRIDGE VA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 66 of 66 people found this instruction helpful
...on the lower rack of the dishwasher. I simply snapped the pieces together and then snapped them into place. No tools necessary other than my own two hands (and the scissors I used to cut open the package!) read more

Wheels on bottom rack were either broken or melted

  • Customer: Maria from wright WY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 78 of 142 people found this instruction helpful
It was really easy I just snapped the axle and the wheels together and then snapped them onto the rack! simple as that read more

wheel axles are defective - wheels fall off

  • Customer: Chris from Decatur GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 75 of 138 people found this instruction helpful
The part indicated here is a new design to replace a defective part that fails to keep the wheels on the lower dish rack. So far, the new axles work fine. Removal/Replacement couldn't be easier - it is helpful to use needle-nose pliers to get the old axles out. The new ones just snap in. Wheels stay on just fine. The rack is designed to roll on 8 total wheel... read more