GHD5035F01WW General Electric Dishwasher - Instructions

Replaced the water-fill solenoid valve.

Overall easy-peasy. The hardest part was getting the dishwasher out from under the counter, once out the problem was self evident, the rubber fitting ( end of hose to dishwasher) was deteriorated. The insulation blanket was water soaked also. The actual time to replace the hose was less than 30 min. but the total job took 3 days, ordering and delivery of part( PartSelect 2 day service) and drying of insulation blanket. The rubber fitting into the washer is tight, I used some Vaseline. Have plenty of towels ready when any hoses are disconnected, they are all full of water. Good luck .Cheers Fritz

Pieces just snapped together. Simple an quick. Part select was wonderful in assisting.

Watched the on-line video. It was great and made the replacement job easy. Without the video, I probably would have broken the plastic end caps while trying to take them off. I highly recommend watching any available repair videos.

Removed existing gasket seal on door. Cleaned really well with a household cleaner around the gasket crease. Installed new gasket seal around door. Started with small notch in the middle of the gasket to center on top and then slowly fastened into door edge and slowly snug around bottom edge where the deal is notched and the the difficult part was to feel the seam again on the bottom to re attach seal after notch from corner. Rupert this on the other side of door.

I followed the video instructions..I was concerned that the end pieces would be a problem, so I purchased replacements also, but they came off with no problem - thanks to the video.They only cost about $2.50, so I will keep them in stock in case I need them at a later date.Without the video, it probably would have driven me nuts trying to figure out how to remove the end pieces, but when you see it done, it was simple.....Thanks Loads.