Models > FDB1050REM2 > Instructions

FDB1050REM2 Frigidaire Dishwasher - Instructions

All Instructions for the FDB1050REM2
466 - 480 of 650
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Water not entering dishwasher
Removed lower front panel and kick panel. The part was accessible from there. No need to pull the dishwasher out from under the counter top.
Parts Used:
Water Inlet Valve - 120V 60Hz
  • Ernest from Sayville, NY
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers, Wrench (Adjustable)
Was this instruction helpful to you?
Thank you for voting!
door strike broken
Unscrewed dishwasher from cabnet. Removed nuts holding old strike in place. Put new strike in place and then reattached bolts to hold strike down. Followed by reattaching dishwasher to cabnet. Ready to use
Parts Used:
Door Strike
  • Janice from Conway, NC
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
leaking aroung the door
replaced gasket easy-peesy
Parts Used:
Dishwasher Tub Gasket - Gray
  • cody from kalispell, MT
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Bad leak at bottom
Pulled old gaskets out, I could not get the bottom seal in until I used a mirror to see the slot it fit into, then it went right in, Tub seal was a brainless install.
Parts Used:
Dishwasher Tub Gasket - Gray Dishwasher Bottom Door Gasket
  • Wane from moville, IA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
Was this instruction helpful to you?
Thank you for voting!
broken spring on door
replacing spring is easy.but you have to disconect the water line to slide the washer out to get at the spring.service was exelant. part was deliverd next day.
Parts Used:
Door Spring
  • Ralph from Berlin, NY
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Screw drivers, Wrench (Adjustable)
Was this instruction helpful to you?
Thank you for voting!
original rack wheels where bent and upper wheels had melted
husband replaced wheels.
Parts Used:
WHEEL & BUSHING ASS
  • Sharon from South Park, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
wheel missing
2 wheels were missing and I replaced them in 2 seconds. The diagram online was a huge help!
Parts Used:
WHEEL & BUSHING ASS
  • WILLIAM from KENNESAW, GA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
Was this instruction helpful to you?
Thank you for voting!
Had to replace the drain hose (that I screwed up)
I already had the dishwasher removed for remodeling. I wrecked the drain hose myself. When I received the replacement it was a breeze to install.
Parts Used:
Dishwasher Drain Hose
  • Steven from Wauwatosa, WI
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
Dishwasher Leaked at the door
I replaced the bottom gasket first. It was kinda of tricky after pulling the old one out. The video on how to install it was very helpful and the installation took about a minute. The tub gasket was easy and fit right in. I just had to cut off the extra so it would fit in.
Parts Used:
Dishwasher Tub Gasket - Gray Dishwasher Bottom Door Gasket
  • David from Middletown, DE
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
silverware basket cracked and broken--utensils falling through
received part the next day. great service
Parts Used:
Silverware Basket
  • Mary from Garden City, NY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
dishwasher would not start
replaced handle and latch assembly switches
Parts Used:
Handle and Latch Assembly with Switches
  • CATHY from Bailey, CO
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
needed new lower rack
opened door took out old rack installed new one took less than 5 minutes.
Parts Used:
RACK ASSEMBLY,LOWER,GREY
  • Randal from Hoover, AL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Dishwasher leaking arond the door.
I checked with the possible causes and ordered the gasket suggested. I then clicked on how to replace the gasket and followed the directions given. Pretty simple.
Parts Used:
Dishwasher Bottom Door Gasket
  • David from Leesburg, FL
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Water discharge (around door) during Wash Cycle
After reading some "Suggested Installation Instructions" on the Parts Select Website, I felt at ease tackling this job. After opening the door, I simply pulled-out the existing door gasket. The installation involved simply pressing in the new gasket with my finger and insuring it was properly seated. The only tool I had to use was a pair of scissors to cut the excess length as I pressed it in. REALLY APPRECIATED THE SIMPLE INSTALLATION INSTRUCTIONS as I had never done this particular task.
Parts Used:
Dishwasher Tub Gasket - Gray
  • Gary from Roseville, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
water inlet valve was leaking
Could not identify the breaker for the dishwasher so I turned off the whole house. Turned off the water supply. Removed the leaking valve fairly easily - the clamp that holds it in place was a little tricky. New valve went on easily & again the clamp was a little harder. It was successful since there have not been any further leaks. Location of the valve & having to lie on floor to do repair was a factor in the ease of installation.
Parts Used:
Water Inlet Valve - 120V 60Hz
  • Jack from Wilton, ME
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers, Wrench (Adjustable)
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the FDB1050REM2
466 - 480 of 650