EMO3000CBB04 General Electric Microwave - Instructions

Simply unscrew the bottom panel of the microwave device (it swings downward when opening - there are hinges on the back to protect it from falling down). Remove the old light socket (which is modular and is screwed in place)from the connectors and then replace it with the new light socket. That's it

Replaced light socket and bulb. Real easy repair.

lowered bottom cover removed wires from motor removed two screws from motor put in new motor and put cover back on with the six screws that held it on. plugged cord back into outlet. very good instructions and very easy to install. my wife was impressed.....recieved part qiuckly very good service.

As easy as putting the tray inside the microwave. Part fit perfect!!

Removed the bottom cover of the microwave and replaced drive motor.

Snapped on new plastic piece!! Super easy!!!

The microwave is mounted above the stove. I left it in place while making repairs. I unplugged the microwave. I removed 3 phillips head sheet metal screws, bottom front and 2 phillips head screws bottom rear. The bottom cover swung to the rear of the microwave and hung on hinge tabs. I popped the turntable coupler up and off with a table knife. I removed 1 screw on the drive motor and slid it out of a slot on the other side. I pulled of the electrical plug and installed the new drive motor and turntable coupler. This is a really easy repair.

I removed the bottom plate of the microwave, unscrewed and unplugged the motor, screwed in and plugged up the new motor. VOILA, DONE! $40 is lot better than $350 for a new microwave. Thanks PartSelect.com.

my wife removed the bottom screws and replaced the motor.works normal now

I could not repair this by myself..Thank goodness I have a "go to guy" who came and "fixed" the problem..I was told that this was not the part needed for this turntable..did not need this "extra piece sticking out of the side" with this extra thick "lip" sticking out of the side of the coupler, the coupler did not fit..Thank goodness for my "go to guy"...

Screw driver to remove two screws all the tools needed. Part was expensive (microwave new was $250 and vent grill was $89). Recieved part within 48 hours after ordering with ground shipment. (Quick)

replacement door recommended $308.00 ! said no parts available ! I looked online and found one for $ 35.00 ! then i found your site and bought it for $3.00 !!! It came very fast. We looked up schematics on your site and looked on u tube for video of how to repair it. and my sons put it together in 15 minutes thank you!!!!!

My son had to replace the bulbs because the screw that holds the bulb shield was so tight that I couldn't remove it. It was too difficult for me to do it myself.

Located the correct part on PartSelect. PartSelect had the correct diagram. Replacement of motor was easy to do. All I had to do was remove the bottom panel to access the drive motor. This is a wonderful service.

I read the suggested procedures on this website and they were 100% accurate. Made the job a very, very simple process. Probably would not have tackled it except for the extensive instructions on the website.