EDW3000G03CC General Electric Dishwasher - Instructions

Immediately shut off water supply to the washer. After ordering and receipt ot part: Removed base panel, turned off power, disconnected wire, water supply line and screws attaching washer to kitchen counter. Pulled the washer out and turned it on its side with the valve on top. Removed and replaced the valve, returned the washer to the upright position, pushed it back under the counter, reconnected all services, screws to counter and base panel, turned on the water and power. Took two hours since I needed take a trip to the hardware store to replace a right angle water fitting .

Took of the plactic strainer shroud unscrewed the piston nut assembly by hand installed the new one it takes longer to remove the shroud than it does to replace the part

Briefly, after a power outage...detergent door wouldn't close,and when washer was started would cycle over and over without stopping. Thought control module & door motor were at fault. As it turned out, due to the variable power changes the control module wouldn't reset properly and kept cycling. I opened the washer and removed the inner liner, re-positioned the door arm on the motor, re-assembled liner and closed. Plugged unit in and put door lock in locked position..which activates unit. Heard detergent door motor resetting, and the control module reset properly to normal-heated dry position. The fact is that knowledge of the operating procedures could save hundreds in parts and repairs by trouble shooting the system before ordering parts.

Researched the repair solution online, ordered the part from Parts Select that was way less expensive then the manufacture and 2 other parts sites. Very easy to fix. Saved $$$ and time! Love It

Replays the wheel

Watched the how to video, ordered part, part arrived 5 days later. Popped out end caps. Took out rack, replaced wheels and boom less than a minute later it was fixed. Now my kids can do the dishes safely. Momma has a way out of doing dishes now.

Original parts broke off at the wheels and wouldn't stay attached to the basket when pulled out for use...replacement was simple strait forward...remove the old, and on with the new.

Insert the piece into wheel and snap on lower rack of dishwasher. Thank you to parts select for such fabulous service and quick delivery and fair price.

Had just a little trouble getting the end caps of the the runner bars after that it was a breeze, I am a 55 year old woman and done the job by myself

I watched the video before ordering to ensure I had the right parts. I simply followed the video. So easy! And for less than $20, the dishwasher is repaired. The upper rack was such a hassle, I was considering getting rid of the dishwasher! So glad I found your site.

Remove filter screen at rear bottom of dishwasher with 1/4 in socket, remove check valve by hand, install new check valve, reinstall filter screen. Run a load of dishes, drained completly.

I found Parts Select on the internet and checked out the website. Very easy to use and fund the exact part for my dishwasher. Ordering was simple and delivery was wuicker than expected. Very impressed with your service and will use again in the future as needed.

just lifted out the old one & replaced it with the new one. Couldn't have been easier.

The hard part is removing the end caps on the rails. By the time I did that, I had broken one, and the rail was out of its guides. To fix the rail, needed screwdriver to remove two guide wheels, then replace them. Glued broken cap; that failed. Now I've ordered new caps; after that, it should be a breeze. MY ADVISE: order new caps when you order the rack. They're only $ .61, and you'll save both delay and a second shipping cost.

Before you due anything else...remove the water inlet valve, remove the 4 screws holding the water inlet coupling to the valve housing, remove the nylon filter (tight fit), and clean the debris from the filter. Re insert the filter, reassemble the valve housing and check for leaks. Clears most water flow problems.