ED5VHGXMB10 Whirlpool Refrigerator - Instructions

First, I took out the broken unit,yhen I put in the new one..

Unplugged the fridge and removed the cover from the Icemaker control assembly. Then remove the three phillips head screws, remove the Icemaker control. put the new control in place and use the three screws removed in previous step, replace the cover and plug the fridge back in. in a few hours you will have some ice.

Replaced the icemaker control assembly and ice mold. Icemaker is working perfectly now. We replaced the ice mold (tray) because my husband read on the internet that the ice mold loses its nonstick coating and the ice sticks to the mold, and eventually burns out the control assembly.

The reason it took me longer than what should have been a 15 minute repair is due to the fact that I could not figure out how the shaft came apart. I found an instructional video on Parts Select website that showed me that the shaft was held together by a reverse treaded, round nylon nut on the very front of the shaft. Just use a pair of pliers to grasp the nut and rotate it clockwise, after that you just need to lay the parts out in order as they come off the shaft so you can put it back together again.

This was a very easy repair and only took about 20 minutes. Unfortunately, after reordering, and installing the second motor, the intermittent noise is still there. Other than the occasional buzzing noise, that sounds like it is coming from the evaporator fan area, the refrigerator runs fine.

Simply follow the video instructions. Involves the removal of nine screws. to remove the old plastic sleeve cut the tube near the old thermostat and it slides of easily. Apply dish or hand washing soup to the new tube when putting the plastic sleeve onto the new probe. The hardest part is getting the end of the probe coiled to the right shape. Hey,` if I can do it with a broken collar bone, anybody should be able to do it.

Pretty much followed the how to video. Biggest pain was removing the screws to the bracket that houses the motor.

took old one out, and put new one in.

I have not broken it but afraid to force the ice new ice guide into position. Crisper drawer no problem . Thank you

Attached new one to filter...

the part was replaced in less than minute

replace drawe

Read the instructions, watched the video and followed the very clear instructions and lay out.

Repaired it using the video that you sent through email. Thank goodness for the video or would still be trying to fix it!

Removed the door (3 bolts on top). Removed the old plastic door closing cam on the bottom. Installed the new one. It was too tall (probably my fault), so I trimmed it with garden shears (it was a tubular piece of plastic). If you do this, be very careful, as the shears cut through the plastic MUCH easier than I thought. Popped the new one on, re-secured the door, and it works great now. Thank you partselect!