CSX24GRSBWH Hotpoint Refrigerator - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
old ice maker was rusty had not been using it
order new augerand ice bucked changed face plate 4 screws now have good clean ice
Parts Used:
-
Wilbur from Brazoria, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Ice Maker not making ice
The video on the GE site was great. Showed step by step instructions on how to remove the old ice maker and install the new one. Also helpful was the detail on the water chute which needed to be moved from the old ice make to the new one. Saved hundreds of dollars by not having to have a repairman do this work for me.
Parts Used:
-
George from Katy, TX
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Could not select Ice or Water, switch would not connect
Pop off the Plastic cover over the Ice maker panel in the door.Remove the 4 Phillips screws. Pop off the rubber Switch pad in the back. Open the Freezer door to disconnect the power and stop water flow. Pull the assembly forward watching the water spout pull through the gap in the lever. Disconnect the white connector by gently pulling it up, it assembles only 1 way. Pull the 2 switch knobs off. With the assembly loose. there are 2 Phillips screws that need to be removed. The cover comes up, and the pc control board slides out. Insert the new control board and reverse the procedure. Be a little careful when inserting the assembly so that the water spout comes through the gap in the lever.
Parts Used:
-
Steve from Gastonia, NC
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!