CSX22GRBKAA Hotpoint Refrigerator - Instructions

Followed instructions that came with time, also viewed the video of website.

I watched the how to video and followed the instructions. The entire repair took less than 4 minutes. Hardest thing was disconnecting the control panel.

replaced the ice buck, not difficult at all thanks for having it.

Repair was really easy, bought the part because of partselect video. Saved myself a lot of money vs calling a repairman.

Followed the instructions. Smooth as silk. This part is better than the original. There appears to be a sensor that beeps when the ice reservoir is full.

Part came in on time, and the repair went smoothly - no problems

I followed the instructions on the youtube video on the company web page. I removed the cover by hand, removed the exisitng flapper door and install the new door, easy as pie.

turned water off removed old water valve moved wires to new one moved water supply and discharges to new one reinstalled new valve

Followed easy video instructions. Loosened the necessary bolts, etc. Replaced hinge assembly, lined up door, lubed the hinge with vasoline. Works perfectly now. May purchase another assembly as spare as it appears this may be a common repair issue.

Took the paper clip, pressed in through the holes on the bottom of the ice dispenser panel. Removed the four screws. Loosened the panel and removed the wires. replaced the flapper door. Then reversed the process. Your video was VERY helpful except for the paper clip. Had to get that off another web site.

I used the how to video from the site and had the part replaced in about the same time the video did it, even with being distracted with a phone call.

Removed the old broken one with screw driver and installed new one with screw driver and voila all done!

did it just as the video showed. it was a little different, but absolutely nothing that we as ametures could not figure out! very easy and I think it was just the part we needed! biggest thing was unloading refrigerator!

As mentioned by others, the rivets is the main issue with this repair. Those suggesting to drill it out were helpful - except I might add that the location is hard to get a drill bit there. What I did was bend the supports slightly downwards. This permits you to drill straight onto the rivets. Once worn down I used a pliers to yank them out.

I spent 15 - 20 minutes just hunting/deciding which of several sets of parts & directions to follow. The provided directions were not bad; but none of them quite matched my GE ADORA side-by-side model. Once I came up with the actions I would need to take...I was done in 5 minutes! The kit , as I said, came with all the parts one could need (and one or two un-needed parts included for other model GE refrigerators) I am very happy with PART SELECT...altough GE doesn't rate as high with me for their declining reliability.