CSK24GRXAAD Hotpoint Refrigerator - Instructions

My husband made the replaced the flapper while watching the video provided in your email, it was easy. Thank you.

Followed the video directions. Spent about 5 minutes and I was done. Very easy to do. Problem with frost is gone. The video makes it easy to remove the plastic parts without any damage.

Watched your video a couple of times, just to be sure I had the sequence down pat. The repair followed the video exactly and was completed in about 12-minutes. I was a bit leary whether I would be able to handle the door weight and alignment but it all went into place without any problems.

I ordered a cam riser for the refrigerator door. I watched the "how to" video the day I ordered the part. It took about a week to get the part, but I was ready when it arrived. The 'how to' video was a big help. It showed me how to take off the door and replace the part. The process was quite simple! Oh! Don't forget to turn the refrigerator on again!

Installed new replacement slide rail. Only two screws hold it in place. Very easy.

Watched PartSelect video and did exactly as video said. Had finished product in less than 30 minutes.6 bolts and one screw.

Per you video. Without it I would have probably taken a lot longer that necessary. You will never know how much I appreciate your including the video. What customer service. Outstanding.

I started removing the switch by prying on the right side with a screwdriver, when it emerged enough I used pliers to finish removing it. I then unpluged rhe wires from the bad switch and pluged them on the new switch and "poped" it into the hole.

Ordered both rails to make sure they matched. Unscrewed old broken rail and other side. Screwed on new ones. Real easy and perfect fit. Unfortunately I didn't notice crack in drawer until then, so had to order it. Both ordered arrived in only a day or two and had the refrigerator back up and working easily.

Followed the video to replace bottom hinge assembly. The only hiccup was that the video instruction was for the fridge side door, so there wasn't step by step instruction for dealing with the electrical connection at the top of door or the water line at the bottom. However, it was simple enough to figure out. Replacement took about 20-25 mins.

put in two screws"very easy!!!

What a snap. I was so proud of myself, kept sliding the drawer in and out after the slide rail was installed. I thought I never would be able to fix it and I'm so glad ge had the piece that would fit into this older model refrigerator.

Snapped off the plastic plate covering the dispenser. Removed the four screws holding the mechanism in place. Remove the electrical connections. Pull the mechanism out and up carefully pulling the dispenser pad out with all the mechanism in place. Look at the mechanism before removing any parts to get a mental image so that reassembly will be easy. Remove any electrical switch or circuit boards and remove old parts before submerging the mechanism in hot soapy water for clean-up. The Clean-up will take longer than the disassemble and reassembling. After completion the dispenser works as it should.

Pulled out old actuator pad worked the control for several minutes to free up the mechanism to make sure water would turn off. Then installed the new actuator pad.

Removed door with little or no difficulty. Only time consuming portion of repair was disconnection and reconnecting of water line to door. This difficulty was primary due to age of the unit. After repairing, I determined that the cam on the refrigerator was also damaged so ordered same part to replace the refrigerator side.