CSH24GRTAAA Hotpoint Refrigerator - Instructions

Unscrew 2 screws to remove broken part, screw in new.

Watched video on the parts order information page and did the repair. Very helpful made me feel like I could do the repair

First, depending on when you find out your problem, be prepared to toss out spoiled food. Unplug the unit. Since you must allow the ice build up on the coil to melt, be prepared for water. Use towels placed under the coil in the freezer to soak this up or it will end up on the floor. Remove ice maker bucket as the ice will melt, that is if there is any. In my case the defrost timer was bad but I later learned that my defrost heater was also bad. Do yourself a favor and change both the defrost timer and defrost heaters. This issue is generally an age issue so replacing both will give you peace of mind. Also, clean the whole freezer as this is the time to do it. You will be surprised at the ice maker bucket cleanliness. Time to prepare and clean is what takes additional time. Time to repair is short and simple. One last thing, when replacing the defrost timer try not to mess with the temp. control slides as you will have to put them back in the proper positions for reassembly of the cover.

Ordered part on line, arrived the next day. Looked at the screw (phillips head). Had trouble dropping screws but got our magnetic phillips head and it worked like a charm. So proud of myself as my husband did not have to do a thing.

Solenoid pushing the crushed ice flapper was burned out. Solenoid was easy to find unplug and replace. I used the old piston which simplified things. Now works great

Ordered this part after i replaced the plastic tubes on the back as the problem persisted. loosen the nuts holding the water inlet lines, remove the cover to the valve. remove the valve and the water inlet line to the the valve. Disconnect the 2 outlets from the valve. 1 outlet to icemaker and other outlet to water cooler (bigger). Connect water inlet and 2 outlets to the new valve, test the water lines. Found the inlet is leaking, removed it and added teflon tape and reconnect it. All is done. Then I left the freezer door open for 3 hours to melt the ice on the wrong places and all is well.

Followed the online video exactly and it was easily done. Couldn't have been better. The problem is solved.

I just followed the video instruction supplied by PartSelect and the whole thing was a breeze.

We watched the video and it was super easy! Once the circuit board was replaced, everything worked perfectly! Thanks so much for helping us keep this refrigerator in working order!

Removed freezer door, put a blanket over the opening to keep food frozen. Installed hinge and replaced door.

the pad is a slip in I just used grease to allow for the friction and had it in with in a minute

Followed the u tube video that was on the Part select website. Very easy install when following the video.

I first replaced the ice bucket which allowed the auger to turn but did not fix the problem. I then ordered a new solenoid and plunger and after installing them it now makes ice cubes. Problem solved.

Removed frame, unscrewed the electrical panel, and popped the flapper off. Installed new flapper. Replaced the electrical panel and re-installed the frame.

Fairly easy I pull the fridge foward and remove the backing board and notice the fan wasn't working, so I remove the fan and bench tested and it was burned then I clean the condenser with compress air if you don't have air then a vacuum cleaner works then once the part arrived I install it the now if working very good