30TESKWED-04-23 Tappan Range - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Front drawer glide broke off and drawer had no support on left side.
Watched on-line video to confirm I was ordering correct part and installation took less than 30 seconds. Video was very helpful.
Parts Used:
-
Janet from Villa Rica, GA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
bake element was burnt out
turned off the braker to the stove then loosened the two screws removed the old element put in the new element tighetned the screws turned the braker back on its working fine
Parts Used:
-
marlene from pickensville, AL
-
Difficulty Level:Really Easy
-
Total Repair Time:More than 2 hours
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
element made a loud noise then caught on fire.
Followed the online video instructions.Thanks for the step by step online video.
Parts Used:
-
teresa from rosehill, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
Old rusty worn out oven racks
-
June from Mt. Vernon, AL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
My bake element had burnt out.
The element was relatively simple to put back on. While holding the connecting end coming from the back of the stove into the oven. I pushed the new element into the connector. It went in place perfectly.
Parts Used:
-
sandy from richmond, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers
Was this instruction helpful to you?
Thank you for voting!
the bake coil broke
I watched the video that was posted on the parts website when I ordered my part for my oven and it was sooooo simple now I'm back to cooking and my part was to my door in1 day after I order would definetly use this company again.
Parts Used:
-
angie from lake stevens, WA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Element burnt into
Used a nut driver to remove old bake element and removed slide on clips on each side took the old pieces to trash and the put new element in by installing slide on electrical connection the tightened up screws with nut driver it was easy and the best thing was ordering of the part and getting the correct part in a timely fashion. I wish all websites were this efficient.
Parts Used:
-
Stacey from Abingdon, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Oven would not heat.
Turned the main power off to my oven. Got my part removed two screws took the old bake element out put the new one in, replaced screws, turned power back on and boom it was fixed. Thanks so much for making it so easy.
Parts Used:
-
Nanci M from Greenwood, IN
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Element burned out
Removed two screwa holding element in place. Removed the connecting wires. Attached wires to new element. Reset emlement, replaced the screwa and I was done. Actuallt, I did as exactly as indicated in your film discribing the installation. P.S.-Part arrived in two days inspite of the impending hurrican. Extremely satisfied.
Parts Used:
-
RICHARD from CORAM, NY
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Socket set
Was this instruction helpful to you?
Thank you for voting!
replace a broiler calrod on a tappan oven.
if iever need to do this again i will unplug the stove and take the back off. iwill remove the spade connectors from the back and remove and replace the unit from the front. from the rear i will replace the spade connectors and the insulation . plug in the stove and make sure everything works. unplugthe stove, put on the back,plug in the stove and position it.
Parts Used:
-
ronald from palatine, IL
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Pliers
Was this instruction helpful to you?
Thank you for voting!
Burnt-out bake element
My wife had seen a small fire in the bottom right of our oven, and I quickly turned off the oven unit, which put out the fire. We tested the oven a couple more times after it had cooled and determined that indeed the bake element had burned out. I'd used PartSelect before and been very pleased with their service (speed, ease of use of site, etc.,etc.) so I ordered a new bake element, which arrived in two days! It was easy to replace: I turned off the circuit breaker, slid the oven out from the wall, disconnected the plug, and then got to work undoing the tabs that hold the bake element to the rear wall. The only little glitch was that the screw heads on our range were neither slot nor Philips - they turned out to be small square-socket screws. I couldn't see that until I turned a bright flashlight on the job. Then it was a simple matter of trading out the screwdriver bit, disconnecting the old element, plugging in and attaching the new one, and away we went. Oven as good as new! Thanks, PartSelect!
Parts Used:
-
Henry from Stow, MA
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
element broken in half
followed the video provided and installed it as instructed. Video and instructions provieded were very helpful
Parts Used:
-
James from Dallas, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Heating Element broke
Remove bolt from both ends of element carefully as not to damage wires connected to the ends. Replaced with new element. Simple.
Parts Used:
-
Jennifer from Columbia, MD
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Socket set
Was this instruction helpful to you?
Thank you for voting!
rear drawer glide/problem was when wife saw video
It took about 3 years to order and 3 minutes to fix. forgot to turn off "easy" video on conputor. Wife watched was mad........... for taking so long to fix. 41 years married, any video to fix wife and get me to 42 years as easy as changing draw glides? Thanks Jon
Parts Used:
-
Jonathan from East Millinocket, ME
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
One terminal was hard to remove.
Turned off electric at breaker box for range. Using a socket wrench from my little pink tool kit, I removed the two screws holding the unit at the back of the oven. Gently pulled each side of the unit out, exposing the terminals. Holding with one hand and wiggling the terminal with the other, removed the element. One was very easy, but the other was harder. Next I connected the new element to the terminals. Gently pushed the terminal back into the oven wall and replace the screws. Last turned the electric back on and then turned the oven on. The video that was online was very helpful.
Parts Used:
-
Alma from Lonoke, AR
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Socket set
Was this instruction helpful to you?
Thank you for voting!