10659422801 Kenmore Refrigerator - Instructions

Removed old valve. New valve does not provide for filter without modification. oOld valve used compression nut which had to be removed. Smooth cut with utility knife and push in. Needed a 1/4 inch compression coupling to hok up ice maker connection to 1/4 inch plastic hose fro the valve.

I watched the video a few times and pretty much did as it said to do. Took about 20 minutes start to finish. It seems to be working 100%.

I took ice bin apart to ensure what part I needed. Got Serial # & Model # from inside fridge. Online search for Whirlpool Parts to check out prices. Settled on PartSelect for best price. Quick service too!!! Before putting it all back together, I reviewed the video. It was pretty good. Just left it up & after each couple of steps, I'd look at what was next. Went together with no problem. There could have been more details given, like ensuring that certain things lined up during reassembly. There was dead time when the narrator could have given pointers.

Took 1/4" nutdriver and loosened the two screws on top then removed the one screw underneath. It came out except for the wiring harness attached. My icemaker came with a wiring harness, but I elected to unsnap and use the one in the freezer to keep from doing more work on connection. Replaced the bail and heard the first ice drop in a couple of hours, then more ice till it was full the next day.

Easily installed the part on Tuesday night. Had ice by Wed morning.

I shut the unit off for about ten hours and when I turned it back on and set the temperatures for the freezer and refrigerator it has been working great.I will keep the part in case it happens again.

watched the installation video twice and took my time to make sure all parts were put back together in the right order

Followed instructions in video and instructions by other home owners. Installation went very well. Parts Select shipped the repair kit. A good company to do business with. Saved a lot of money by doing the repair myself.

unwrapped the packaging, and dropped the shelves in place, 5 minutes to complete"

I unloaded the door, removed the cap covering the screws at the top hinge. I removed the screws then lifted the door off the pin. Next I removed the screws holding the door cams in place. Replaced both cams and screws, set the door back on the pin then reinstalled the three screws at the top. Snapped back on the cover and I was done. Door works perfectly.

Removed ice bucket so ice would not dispense while working on ice guide. Removed damaged ice guide by prying 2 clips with a flat-head screw driver. Installed new ice guide by pushing beyond final position, lower bottom clip into position, then snap 2 side clips into place.

I emepted the drawer slide it out and replaced it with new drawer . Then I filled the drawer back with food i had removed. The cap was easy. I just removed the old one and replaced it with the new one.

I followed instructions in the video you provided. No problem at all. Took less than an hour.

Just looked at your video twice and then did it with no problems. Thanks

took one screw completely out and the other two only out enough to remove the old icemaker and unplug it from it's electrical connection. plugged up the new icemaker and hung it on the two top screws and put the third screw in and turn the water back on and bamb ice again.