Tenant complaind that oven door gaskets were worn out.

ApplianceGlenwood Range


Level of DifficultyA Bit Difficult

Time to do repairLess than 15 mins

Age of ApplianceMore than 10 years

Tools Pliers

David From Albany, NY

Apr 09, 2008

7 out of 9 people found this instruction helpful

No "repair" needed, just parts replacement. The oven door had (3) rubber-like gasket strips, held in place by metal strips at each end of the gaskets, which fit into 3/16" diameter holes in the oven frame.
The (1) gasket ordered for the "horizontal"/upper position was an exact replacement and fit like a charm.
However, the pair of (2) gaskets ordered for the "vertical"/sides position were not designed for this range and needed MODIFICATION in order to be installed. Specifically, the metal strips at the end of the gaskets were TOO WIDE to fit into the existing holes in the oven frame.
I was able to make the metal strips Using a pair of needle-nose pliers and a pair of nipper-pliers, I was able to flaten-out each of the four metal strips, cut each metal strip [basically in half], re-bend the halfed-strips into "hook" shapes, and then re-insert the metal hooks into the existing 3/16" holes.
So far, so good; no complaints from the tenant!

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability


Part Number: PS123808

No Longer Available

Oven Door Seal (Now subbed to Oven Door Seal)

Part Number: PS1643517

In Stock

Door Seal (Now subbed to Door Seal)

Part Number: PS1643520

In Stock