2 of 3 people found this instruction helpful
Level of DifficultyA Bit Difficult
Time to do repair:Less than 15 mins
ToolsNutdriver, Screw drivers
CustomerWayne from Lafayette CA
Not enough water in the ice maker. Made thin ice cubes and only one or two at a time.
Replace the water solenoid vave. Shut refrigerator off. Removed water filter below the door. Removed the front cover. Reached back and shut the water valve off. Remover the 2 screws holding the water valve to the bracket. Took the electric connector off the valve. The fitting are tight. Hold the ring down, push on the tubing and then pull the tubing out. Replace the tubing in the new valve and the electric connector. Reverse the procedure. I ran a test before putting the front cover back on. It takes some time but can test amount of water in the cube maker with your fingure.