| |
4 of 8 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers
Customereve from carrollton GA
Ice & water dispenser wouldn't shut off
Took the trim piece off, took 4 screws out & replaced the part. Problem solved!
|
3 of 6 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerDALE from JACKSONVILLE FL
Door dispencer wtr/ice ran continuously.
First I removed the front cover (pried a screwdriver gently under the bottom plastic seal between housing shield and front cover, it came off nice and easy without damage).
Removed electrical plugs from electronic board (front cover) so that it did not hang from the wires and get it the way. Then removed four screws holding housing shield on. Removed housing shield, first observing with new parts next to me how it came apart. and then disassembled funnel from shield. Simple but being careful is the key to putting the new unit together as with any plastic parts it's easy to snap if forced.
Replaced all parts in reverse order removed.
This is a good time to clean all parts for any mold build up that could not be reached otherwise.
Parts select personnel were courteous and very helpful. Especially when I almost ordered the wrong color parts. Ask questions if not sure.
|
2 of 4 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:30 - 60 mins
ToolsScrew drivers
CustomerRoy from Tucson AZ
Ice cubes fell on floor
Removed front cosmetic panel on freezer door. Removed display. Removed display by pressing down and then out. Removed 4 screws holding display panel and then removed. Removed dispensing Funnel. Installed new dispensing funnel onto new funnel extension. Installed aforementioned using reverse procedure of dispensing funnel removable. Rre-enstalled display panel and display. Replace cosmetic panel on freezer door. Works fine.
|
1 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:30 - 60 mins
ToolsScrew drivers
CustomerDON from PETERSBURG VA
Water and ice never flowed from door
Replaced parts by removing four screws.
Old parts were damaged from overheating with a hair dryer because the water line was frozen.
|
1 of 3 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:More than 2 hours
ToolsPliers, Screw drivers
CustomerOLESTER from SAN DIEGO CA
This model is a lemon (on-line for compliants). Numerous problems
Removed 4 screws & replace parts.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers
Customerharold from gramercy AL
Plastic got hot and distorted grandchild turned light don and itgot the parts very hot .
simply removed the parts, and replaced the new parts and disconnected the light switch so it only comes on when using the dispenser and goes off by it's self.
|