8 of 11 people found this instruction helpful
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsPliers, Screw drivers
CustomerTom from Lawrenceville GA
Timer was no longer counting down to finish
Removed the screws holding the Top of the Dryer control panel. Pulled the top off, The section with the controls hinged down for easy access.
Used needle nose pliers to pull off the wiring harness. The timer module has grooves that all you need to do is turnit a quarter turn and it pops right out, no screws or funny clips, real easy.
The new Timer goes in just as easy, line up the tabs with the slot and quater turn locks it in. Repalce wiring harnes on same pins as removed, screw the top back in place and good to go!