Models > DCLR333ET1WW

DCLR333ET1WW General Electric Dryer - Overview

Get Parts and Repair Help for DCLR333ET1WW

If you know the dryer repair part you need, you can browse the list of all parts on the DCLR333ET1WW, or you can search by name or part description. You can also find your part by where it is located on the DCLR333ET1WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for DCLR333ET1WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.62

D-Shaped Knob Insert Clip

Sold individually.

$7.32

Selector Knob with Clip

This white knob accepts a D-shaped shaft. Sold individually.

$46.29

Rear Drum Bearing Kit

This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Helps keep your dryer running...

$8.52

Drive Belt

This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.

$26.67

Rotary Start Switch

This part is used to start the dryer once you have selected a setting on the timer.

$8.98

HANDLE WHITE

$14.88

Idler Pulley Wheel

A dryer's idler pulley wheel serves to help the belt to rotate the drum.

$1.70

Screw

This screw is sold individually.

$33.00

Lint Filter with Frame

This part may differ in appearance, but functions same as original.

$5.73

Drum Slide Bearing

This bearing is sold individually. Some dryers require up to three of these slide bearings. Be sure to check to make sure you order the necessary amount for your dryer.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Replaced broken START knob on dryer.

  • Customer: SAM from ROCK HILL NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 470 of 474 people found this instruction helpful
Slid off the old START knob, then pushed on the new START knob.

I created and printed a label on my computer for use with the time selector dial, which must be set at or beyond 10 minutes, before turning the START knob.

I made a label that says "Minimum" with a red arrow that points past the 10 minute setting on the time selector dial.<... read more

The inside of the Selector Knob was stripped

  • Customer: Frank from Irvine CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 369 of 372 people found this instruction helpful
Removed the damaged knob and replaced it with the new knob. Very ease read more

dryer belt broke

  • Customer: Matt from La Belle MO
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 90 of 103 people found this instruction helpful
first I took the dryer apart 1st thing i did was unplug the power supply (safety first) then I removed the top of the unit then removed the front cleaned all the lint from the inside of the cabinet I found the proper belt size on part select.com the next day I had my dryer belt delivered (which cost 1/3 the price of the local repair shop price)
then I ... read more