Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS231276
This part helps your burner ignite and produce flame.
This part works with the following brands: GE, Hotpoint & Kenmore.
This part fixes the following symptoms:
Assumed the entire top of the range would have to be lifted off. Removed the three screws inside the top of the over door and then noticed the two screws holding the dish around the burner. They were tight and required WD-40 and then a sharp tap and came off. Important: Notice the direction your old igniter is plugged into the wire. It is not clear and can go on either way.
Help other customers find the most helpful instructions.
Were these instructions helpful?
After the parts arrived.Unplugged the stove,and sarted taking a stove apart ,removing (4 torkx screws)from the top,disconnected electrical wires from electrod, and burnerswith,(4ps).left&rigth front tube was installed.also replaced four electrod.Put everything back together with caution plug stove back in, and now,works like new,for other14 years or longer.If you can do the above you can saveyour self a bundle. Thank you parts dept for the good sevice.Happy new year
removed burners from cooktop, hardest part was to lift glass top because of the double back tape holding unit to counter, replaced damaged ignitor clip and reinstalled with new one, placed all parts back, job done.On dishwasher it was as simple as using nut driver to drive 8/16 self tapping screw onto new part and checking for arm rotating without hitting anything. done. thanks guys!
STOVE Much easier to perform than expected. First, pull the plug. Second, lift door off hinges and remove bottom storage door. Then remove bottom tray (2 thumbscrews) and the head spreader below that (1 screw). Now disattach the two wire nuts that attach the igniter to electric (from bottom, where door was). I guess this has been changed once. If it had not been, might have had to cut these lines. Then, back inside the stove, remove the flame delivery tube or whatever it's called. It kind of twists as it pulls up. From there, it's easy to disattach the igniter with a wrench and then reassemble all in reverse order. Hardest part was getting one of the wire nuts to take. One of the replacement ones just did not grab, so reused one of the preexisting. OVEN Only hard part was getting the stovetop to release. Take off all the burner guards and such. Then lift the top slightly to locate the two push clips. Push each back in turn with a screwdriver, and this releases the stovetop, which rises up until it rests on two rests. Piece of cake to remove th electrode and attach new one. All working fine!
First I elevated range top, then removed cracked electride from connector pin. Installed new electrode and lowered range top and all was fine.
It was so easy.I removed the old part with the new with pliers. Voila/// it worked.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.