| |
13 of 13 people found this instruction helpful
Parts Used
-
- Outer Door Handle of Two Piece Door Handle
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsPliers, Screw drivers
Customercharles from round rock TX
Outer handle on microwane
removed trim around inside of door with putty knife.
disconnect latch spring with needle nose plyers.
remove two handle screws.
remove small screw on handle to separate outer handle from inner handle.
replace outer handle and assemble with inner replace screw.
connect handle in door
snap tim back into place
|
4 of 7 people found this instruction helpful
Parts Used
-
- Outer Door Handle of Two Piece Door Handle
Level of DifficultyEasy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerCorley from Fort Stockton TX
Two tiny plastic posts, which cracked or broke resulting in door handle almost falling off
My son-in-law took the handle off. We saw the problem (Maytag put two tiny plastic posts that crack about once a year. This was the 2nd replacement in 2 years.) When the new part came in my 15 year old grandson put it on easily. This is a no-brainer!
|
1 of 1 people found this instruction helpful
Parts Used
-
- Outer Door Handle of Two Piece Door Handle
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerEffie from Hilltop Lakes TX
Followed instructions from internet
My son took the door sealer off. It just pulls off easily. Then with screw driver took out the screws and put on the outer part of handle and replaced the screws and bracket. Took less than 30 minutes after we found how to do it.
|
1 of 1 people found this instruction helpful
Parts Used
-
- Outer Door Handle of Two Piece Door Handle
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerTom from Brecksville OH
Handle broken
remove inner door frame,remove screws holding inner and outer handles reuse inner handle,replace outer handle as needed reinstall inner door frame.
|
1 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsPliers, Screw drivers
CustomerDavid from Fredericksburg PA
Broken inner and outer handle
1. Open Door
2. Use Putty Knife and and carefully separate outer door frame from inner door frame
by sliding the putty knife all the way around the frame from the inside
3. Remove the old broken handle. You should use a pointy nose pliers to take hold of the
handle screws once you have then loose...
4. Install new handle, Make sure it is seated flush in the door frame, then tighten with
two screws (use the pointy nose pliers to get them started . .very tight space to work in)
5. Snap on outer frame.
6. Your done!
Dave
|
1 of 1 people found this instruction helpful
Parts Used
-
- Outer Door Handle of Two Piece Door Handle
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerDan from Riverview FL
Door handle snapped off where screws attach
I pondered getting both the inside and outside parts but went with the outside only. Prying the gasket loose went very easily, and removing the latches went easy too (to expose the bottom screw. I found the inner handle base broken but glued it together, not worrying too much because the real attchment to the door is done with the outer handle screws. I can see why the handle broke in the first place because the screws went in with a lot of torque necessary. I suspect that this weakened the posts so I lubricated the screws and backed them in and out so as not to stress the posts. I think all that is necessary is the outer handle, if you want to save some money. Everything snapped back into place easily and it is done after listening to the wife complain for almost 6 months. Part Select is a great site for appliance repair.
|
1 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsPliers, Screw drivers
CustomerRuth from New Bloomfield MO
Microwave handle was completely broken off
Found info on how to replace handle here. Couldn't have done it without that information! We popped out the black trim on the inside of the door and removed the spring to access the bottom screw. From there it was pretty much easy to see where ever thing fit. Had difficulty getting the tabs clipped in the front of the door.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:More than 2 hours
ToolsScrew drivers
CustomerBonnie G from Port Townsend WA
Microwave door handle broke
I received the door handle in 2 pieces along with one screw to put the two together. 3 days later the 2 screws to attach the handle to the microwave door showed up so I could finally put the handle on. I was amazed that I had to purchase each piece separately and that they pieces were shipped in two deliveries.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:15 - 30 mins
ToolsPliers, Screw drivers
CustomerJoseph from Bridgewater NJ
Handle broke off original microwave door
Separated the inside panel on the microwave door, removed the screws from the old door handle and utilized them to install new door handle. Access to the screws was a little tight thus the "a bit difficult" rating.
|
0 of 1 people found this instruction helpful
Parts Used
-
- Outer Door Handle of Two Piece Door Handle
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerMichael from Chaska MN
Handle broke from our over the range microwave oven
removed screws from the old handle (this took the longest amount of time - 5 minutes, and required a needle nose pliers and a screw driver). Replacing the handle took 2 minutes to screw the handle to the door. Very easy!!
|
0 of 1 people found this instruction helpful
Parts Used
-
- Outer Door Handle of Two Piece Door Handle
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerDavid from Parma OH
Replaced broken door handle
Removed the door from the oven by lifting and unhooking from appliance.
With a small putty knife remove the snap-in ring from the inner door.This will expose the screws that hold the handle.
Replace then put everything back in reverse order.
|