Models > CMV1000ADW

CMV1000ADW Maytag Microwave - Overview

Get Parts and Repair Help for CMV1000ADW

If you know the microwave repair part you need, you can browse the list of all parts on the CMV1000ADW, or you can search by name or part description. You can also find your part by where it is located on the CMV1000ADW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. We’ve also included any installation videos we have for CMV1000ADW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.46

Light Bulb - 40W

Sold Individually.

$2.70

Screw

This screw is sold individually.

$11.24

Air Filter

Sold individually.

$11.80

Black Sleeve Diode

$3.22

Ceramic Fuse - 20 Amp

This ceramic microwave fuse is white in the center, while each end is made of metal. This is a twenty amp fuse.

$10.89

Charcoal Filter

It has a metal perimeter, a metal mesh exterior, and a black charcoal interior.

$49.36

Outer Door Handle of Two Piece Door Handle

Screws NOT included. White in color.

$46.62

Inner Door Handle

This white inner door handle is part of a two piece door handle assembly.

$2.70

SCREW

$71.57

Door Frame - White

This outer door frame for a microwave is competely white.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

microwave oven blew fuse

  • Customer: tad from tamarack MN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 16 of 22 people found this instruction helpful
First I removed upper front grill by removing two Philips head screws on top and pulling off. This exposed the Philips head screw which holds control panel in place. After removing screw I pushed up on panel and it came off to expose fuse. With needle nose pliers I removed old fuse and again with pliers held new fuse in position. With the help of a bladed s... read more

outer handle on microwane

  • Customer: charles from round rock TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 13 of 14 people found this instruction helpful
removed trim around inside of door with putty knife.
disconnect latch spring with needle nose plyers.
remove two handle screws.
remove small screw on handle to separate outer handle from inner handle.
replace outer handle and assemble with inner replace screw.
connect handle in door
snap tim back into place read more

Burned out light bulbs in microwave hood stove

  • Customer: Herbert from Norton MA
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 12 of 14 people found this instruction helpful
I had some difficulty removing the glass plate because of the awkward (upside down) position of the screw that retained it. After replacing the burned out bulbs and replacig the glass plate the problem of replacing the screw involved my dropping the thing several times before I got the screw threads to catch. I got a screw thread to catch enough to hold th... read more