All Installation Instructions for General Electric Refrigerator ZSE27SGWISS

Ice dispenser flap door stayed open

Removed the Control Panel and the outside of the Dispenser Outlet. Removed the Flapper Door and the solenoid. Replaced both parts with new parts, and re-assembled. The pin, at the top of the Solenoid was badly worn and the plastic arm was very rough on the surface adjacent to the worn pin.

Parts Used:

Dispenser Door Solenoid Assembly

Dispenser Door Recess Crank

Douglas from Hickory Corners, MI
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins

Was this instruction helpful to you?

Thank you for voting!

Crusher Cover cracked

I followed the video. Everything was extremely easy, but I am 74 years old, have never repaired anything, and have arthritis in my hands. When I got to the step where I had to push in on the tabs, I couldn't do it. I had a friend push in while I pushed up...voila! But it took two of us. I also had a little trouble putting the spring back as it had been a few days since I had removed it. For us beginners, Steve, close-ups of things would be useful. I LOVE this site, however, and will use it again. You saved me over a hundred dollars! (I know because this lousy part has broken twice before.) Now that I know its name, I will not be crushing ice anymore.

Parts Used:

Dispenser Crusher Cover

Holly from Norman, OK
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Ice Shute Flapper Was Distorted And Did Not Seal Opening Causing Frost Build Up

Removed control panel by inserting small screwdriver in the 3 holes underneath to loosen. Remove 4 screws holding circuit board . Unplugged 3 connectors. Removing circuit board gave access to flapper. Removed flapper by unclipping. Installed new flapper and reversed disassembly procedure. This was 2nd time in 2 years I had to replace this part.

Parts Used:

Dispenser Door Assembly or Flapper

DON from ZELLWOOD, FL
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

broken light switch

Used a small screw driver to remove the damaged switch. Carefully unhooked the two wires and hooked the wires to the new switch. Pushed the new switch into place. Be careful that the wires do not pull back into the refrigerator wall. Took about 15 minutes. Works like New. Easy fix.

Parts Used:

Light Switch

Kenneth from Charlotte, NC
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Refrigerator Fresh Food condenser iced-up. Frozen side OK

Had to remove all the covers and fans to expose the condenser, which was difficult as the parts were frozen to it. The styrofoam covering the condenser made it almost impossible to defrost it. Therefore, I ripped the styrofoam off to expose the condenser. Was not really difficult to fix the styrofoam cover using metal tape. Replaced temperature sensor in aluminum block, and used butyl sealant to secure. Had to also re-install parts of ice-ball kit that were not well covered. Lots of parts to keep track of, but anyone could do it.

Parts Used: