ZRRS6550E (P1130662N E) Amana Range - Instructions

I lifted the stove top and cut the two wire connected to the block. Attached the new wire connectors, new block and checked to make sure it was working. The part that took the longest was getting the screw out of the mounting brracked(it was corroded on). I sprayed some WD40 and waited 5 minuts, it came loose. Then i mounted the new bracket and installed the burner. double checked everything and lowered the top. Done

Discriptions provided by others in this section made it easy and there is little additional insight I can add. The part was delivered the next day. I don't reply to these requests for comments, as providing what I paid for is the expectation. But, this outfit did a good job.

Received the part the day after ordering. Appreciated the quick service and repair took less than a minute.

bought used, oven light was damaged from previous repair attempt, without installation instructions removing the fixture was tricky, had to bend the housing tabs inward w/screwdriver to release fixture (more damage). once out the new fixture went in place quite easily, wires simply hook up, re install back panel, re-connect power, Have a nice Day!

burner replaced

Had to screw off old terminal block & screw on new one

I'm a woman that's very comfortable with tools, and this project took me about 3 hours because I worked slowly and meticulously. I first searched online for instructions and diagrams to disassemble the range top (which you provide on your site!); took the range top apart; disassembled gas cylinders; removed the clock assembly and found that the plastic "hinges" on the case "face" broke and that's why the clock assembly fell behind the stovetop. This piece is not available separately, so you have to purchase the entire electronic clock control assembly which is over $200. My clock control works perfectly, so I removed the clock overlay; cleaned the icky's off of everything; adhered the new clock overlay and then "McGyver-ed" the overlay case "face" back to the assembly with electrical tape, in a beautiful, not obvious way, and put it all back together. Re-hooked the gas and power and voila! It works! Cleaned up my mess and made some hot tea before bed. Now I can bake some cookies this weekend ?! Thanks for this site and the parts you offer! I'm a happy customer!!!

I had already removed the old hinges by removing the screws/bolts and removing the broken hinges from the back side through the drawer below the oven that I had already removed. Took the new hinges and screwed the two metal screws into the top hole on the new hinges after placing hinge in vise, one screw on each then removed them and placed them to the side. Determined the right tap from my tap set, and then tapped the bottom two holes on the new hinges, one on each. Placed the bolts that came with the new hinges into the holes I had just tapped, screw them in, then I removed them and placed to the side. Took hinges and bolts / screws to the oven, inserted hinges in through the drawer that I had removed up to each side where hinges would come back out to the front of the oven. Placed screws / bolts one at a time through oven door frame into the hinge on the back side, and then threaded them into the hinges and tightened. Replaced oven door onto new hinges and checked for correct operation. Door works like new.