ZFSB23DRHSS General Electric Refrigerator - Instructions

Used a small screw driver to remove the damaged switch. Carefully unhooked the two wires and hooked the wires to the new switch. Pushed the new switch into place. Be careful that the wires do not pull back into the refrigerator wall. Took about 15 minutes. Works like New. Easy fix.

Had to remove all the covers and fans to expose the condenser, which was difficult as the parts were frozen to it. The styrofoam covering the condenser made it almost impossible to defrost it. Therefore, I ripped the styrofoam off to expose the condenser. Was not really difficult to fix the styrofoam cover using metal tape. Replaced temperature sensor in aluminum block, and used butyl sealant to secure. Had to also re-install parts of ice-ball kit that were not well covered. Lots of parts to keep track of, but anyone could do it.

took 1 screw out and removed ice maker and slid new one in and replace screw and connected power cord

Changed the broken parts

I called Parts Express, and explained my problem. The representative, She asked if I was getting water in the tray, and I was not. She said that if I wasn't getting water there, then my problem was probably the Dual Inlet Water Valve. I poured some water directly into the tray, and the ice maker made a tray of ice, and dumped it in less than an hour. So, I then ordered the Dual inlet water Valve. My ice maker is working perfect, and I am getting better water pressure from my water dispenser as well. Thank you for your assistance.

Only one problem. After installation I had air pocket in the line, no water. Took out filter and installed plug that came with the unit. System worked so I then put the filter back in.Works Great!!! Saved big money

The diagram was very helpful. Removed four screws and removed ice tub. Removed screw attaching spring loaded arm. Pushed the drive screw towards the front of ice tub with carefully with force. The remaining half broken cup was removed. Drive screw slid out. Put the cup into the screw. Using flat head screw driver between the inserted cup and and the ice tub opening, was able to silde the assembly into place. Reattached ice tub and spring loaded arm. Seems to be working so far. Dispensing cubed ice not crushed ice. Any suggestions

1st, I read many of the other experiences. I unscrewed the 4 screws and took the ice bucket off. It ten tried to remove the housing for the dispense mechanism and found it very difficult to get out. So, I then went to a more rigorous method. I used a long screwdriver and pried the dispensing drive cup up and out of its holder being careful not to exert too much pressure and crack the ice bucket. Once pried out and it came out easily, I replaced the drive cup on the end of the helix and slid it back into place. Had I done this first, my repair time would have been 20 minutes. Always easy after you have done it once.

Snapped it on

instrections were great

snapped the old one out snapped the new one in.

After replacing the pump in the back of the fridge with no luck I finally decided that it had to be up front. So I ordered the front cover, Ice maker, a new auger and the water dispenser control. For a semi-novice the whole repair was not complicated, my wife had to provide an extra pair of hands to get the ice maker unplugged from inside the freezer but after that it was smooth sailing. Just make sure you look at the water feed tube in the back of the freezer to determine if it's plugged.

I removed the front panel from water dispensor placing a very small screwdriver in the three small holes under the panel. It came free and then I was able to get to the solenoid and switch easily. However, my problem was not solved. It turned out to be the secondary water valve in the back of the unit, which is also an easy repair. The problem with repairs like this is you don't know if you're buying the right part until after you have installed it. Returning the parts are easy except for electrical parts which they won't take back once unstalled. All the parts were delivered the next day, although it said 3 to 5 business days.