YMED5900TW0 Maytag Dryer - Instructions

Viewed online video and written instructions that were included in maintenance kit.

so being the WOMAN that I am I decided to take it apart. well low and behold I found out it was the pulley and belt so I decide too order from parts select easiest thing I've ever done yay me

Followed the procedure outlined in instructions included with maintenance kit. My dryer did not have a pully wheel on the idler arm. Instead it was more or less a wear bar formed in a semi circle attached to the idler bar. This is what was causing the noise. The dryer wheels were good and the dryer belt was good too after 10 years of use. The parts in the kit were of good quality and fit perfectly. The supplied instructions were easy to follow.

Video showed 3 ways to remove the top section to access the switch. None of which worked on my unit. Instead there were 4 screws on the rear section of the control panel that had to be removed and then lift it past the top of unit to slide forward to remove top to access the switch after that all was the same as video.

turned off circuit breaker to dryer. pulled out from wall and turned.had to remove vent tube to facilitate moving the unit.took off back panel with socket.popped connecting wires off old hi-limit thermostat. took off old hi-limit thermostat, put on new one.reattached connecting wires.(they clip in and out.) screwed back panel on.turned unit back into position, popping vent tube back into unit.flipped circuit breaker back on.IT WORKED! didn't need to replace thermal cut-off, that was still working, but came in a kit with the thermostat.the worst part was diagnosing the problem and figuring out how to use the multi-function meter i had on hand.such a good feeling to fix it yourself and pretty inexpensively!part arrived 2 days after ordered!helpful to have 2 people to move dryer,hold pieces,hold back panel in place when reattaching.but could be done by one person.

Removed power (un plugged), removed two screws on back top of cover allow top to lift up on installed holders., used screw driver at right front and left front to push in the locks on the plastic holders and lifted top and held up with board. Removed two screws holding the switch and disconnect it from the connector and installed the new switch, and connected to connector back up, removed board, lowered top aligned with the two alignment clips and pressed down to lock in place. Replaced the two screw removed from back, plugged back in the power and test the repair.

The online vidio was very helpfull

replacer upper heat themo

Unplugged the power cord. Removed two screws on lint vent , used putty knife to release clips to raise top at front of unit. Disconnected the plug from front door switch. Laid dryer on its back. Removed two screws to remove front including the door. Vacuumed lint from inside unit. Installed belt temporarily using two pieces of masking tape to hold it in place while properly routing the belt. Gave the tub a full turn to insure alignment.. Reinstalled the front of unit with the two screws. Righted the unit and snapped down the top. Replaced the two lint vent screws. Plugged it back in and done! Piece of cake!

Once I watched a YouTube video showing me how to do the job I ordered the part from you. Am so impressed with your fast shipping and best prices via the Internet. Thank you SO much! The water level switch was easy to install, it ws getting the cover on the washer back on that was hard for me since I am 68 yrs old and have a bad knee. Its why it took me two hours to do what most people could do in 20 minutes.

I unplugged the dyer remove the back and took out the part and replaced it with the new one done !Thanks to your video I watch on the enternet.thank you so much

Followed procedures in Parts Select web site video

Follow your instructions. Thank You

we received the two heating element wires in 3 days and connected the heating element with no problem works great.