YGH5184XPB2 Whirlpool Microwave - Instructions

adjusted clips to proper postion ( 2 min ) snapped in place.Total repair time appox. 4 minutes.

I received the part very quickly after I ordered it-within 2 days! Part was the right part, and had instructions which were fairly easy to follow. It took only about 5 minutes and a screwdriver to install the new vent grill. Awesome, looks great, right part and an ease to install. My neighbor had the same problem and I ordered another which also came within 2 days! 5 minutes and it was installed perfectly also. Appreciate the great service!

Unsnap grille and snap on new one. Took less than a minute.

Slide the old one out of the slot and insert the new one in its place.

Twas really easy considering that all I had to do was place the plate back in the microwave. Easy Peasey

Tray arrived in a short period of time and was a perfect match.

removed perimeter screws from the bottom side and the lower cover is hinged at the wall side. Motor is visible and easily removed with two screws. Take of the old one, install the new one, and reverse the procedure to put the bottom cover back in place. Will nee helper to hold one side of the bottom until couple of screws can be put in on the other side.

Easy install

Took the replacement plate out of the box and put it in the microwave in seconds. I never realized how much of a difference having the correct microwave plate would make. It's great to have it back.

Problem was easily diagnosed using the internet as a resource, problem was a bad stirrer motor. Hardest part of the repair was the removal of the microwave. Once off the wall, you remove the outer cover and a molded plastic casing directly underneath the outer cover at the top of hte microwave to expose the stirrer motor. Removed two screws and two wires and the old motor is out. Did exactly the opposite to install the new motor. The kit I recvd included among other things the motor, a new inside cover, plastic rivets and even silicone to seal the inside cover. I am sure I saved a couple hundred dollars by doing myself.

You had alerted that it was imperative to unplug unit before starting to remove defective bulb. As described, there was silicon on bulb and socket and bulb broke upon my attempt to remove. Had to use needle nose pliers to get metal base of old bulb from socket, then all went well.

I want to thank PartSelect for thier assistance with my grease and filters that were needed for our microwave. We just bought a home and although the appiances are still in good working condition and only 6 years old they have not been maintaned well at all. The filers needed replacing and our local chain of hardware stores do not carry any of the sizes we needed. I went on line and found PartSelect.com and reviewed what they offered. I really could not find what I needed so I called customer service and the women on the other end of the phone went through in great detail as to the sizes and quantities I would need. I have since then received the filters and they were extremely easy to install and fit perfectly. Very helpful site. KDS

Snap the new one in place.

replaced burnt parts

Attached additional 3rd clip using phillips screwdriver, snapped vent into place. That's it. Addionally, I ordered the piece (at roughly one third price of factory) on thursday, it arrived saturday !! Excellent !!