WRTG18X6AQ1 Westinghouse Refrigerator - Instructions

new drawer was received within 2 days and was extremely simple to install.

I had to cut the retainer bar to length and then snap the end caps onto the bar. Then just snap the assembly onto the freezer. No problem!

replaced with new drawer support rail and put drawer pack in refrigerator

I cleaned off the shelf that the drawer hangs from and removed it from the fridge. I took the philips head screw from the back of the broken support rail. Put the new one on, screwed it in and replaced the shelf and drawer.

ordered brackets - epoxy glued all door shelf parts. When dried I snapped in place and then used self tapping screws to give added support to brackets to the door. Draw guide - replaced part and screwed in as directed.

The switch prevented the door from closing about 5 years ago. So I just taped the switch down, and lived without a fridge light for the last 5 years. Painful! And wasteful (food spoiled because we couldn't see it.) Thought I was out of luck, assuming light switches were all the same, got fed up again, and pulled out old switch,,and searched the net for the part number, and just started calling the manufacturer. I got this website after no luck in calling, and took the step to order...and in no time, got it replaced, and we cam see now! It feels like we got a new fridge!

Super easy. We unscrewed the broken rail, and screwed the new rail into place. Much easier than expected!!! We were also pleasantly surprised to have the part arrive the day after we ordered it!

took off bad part-- 1 screw-- took every bit of 3 min. to change

I snapped out the broken piece of the old Door Shelf Retainer Bar End Cap, snapped in the new one and reinstalled the door rack in my refrigerator.

Your sight and excellent photos made selecting the correct part fast and easy. I received the part with 2 days in perfect condition and my repair was completed in out 2 minutes!

I would definitely order from this site again.

Unscrewed the screw that held the suport rail to the shilf and changed the rail. Then I screw in the new rail.

first i removed the screw from the back of the shelf then pulled the old rail off. I sliped the new rail onto the post then replace the rear screw.

Removed the broken piece and snapped in the new piece bought from PartSelect. Later connected the bar between the left end cap and right end cap. All done in few minutes. The new piece fitted well into the location with no issues.

Thanks PartSelect

Snapped the new parts in.. and good as new!

measured lenght of parts looked at parts available and matched the size and use together slip broken part off door replaced with newpart. reinstall retainer to to door no tools needed.