WRT21MR7ASK Crosley Refrigerator - Instructions

pulled down the thermostat cover and unpluged the timer control and replaced it with the new part. total time to repair was about 15 min. there was a vidio on how to replace the new part that just informed me that I did it right!!!!very easy site to find what you are looking for!!!!

Removed the old door (squeeze a little at the ends), Took the new part out the box, and snapped it on. Too easy! This is my 2nd time ordering a shelf door from Parts Select and both have been great experiences! They are super fast, reasonably priced and the instructions/locating the part process is really easy and thorough! I can extend my appliance life a little longer with Parts Select. Thank you so much as this is a money saver.

The schematics on the website allowed me to pick the exact part I needed. The repair was easy.

The purchase I made was for a bottom glass shelve of a fridge. I put in the model number and ordered the glass for that model. The glass shipped, was too big and did not fit.

replaced the defrosting timer and saved a lot of $ by doing it my self.

actually, my wife installed the shelf bins as fast as I could unpack them..

It wasn't rocket science, Iremoved the old pieces with a screw driver andcleaned the connections and replaced them with the new handle. It fit perfectly.

Took out two screws too old piece off put new piece on with two screw I removed earlier. Simple!

removed meat drawer ,,,titled on it;s side , used philip screw drivingto lossen screw ,,removed worn rail and replaced it with new one in less then a minute,,, very easy and cool ,,,

pulled out freezer, went to floor,reached in next to compressor pulled off clip just like on the video.Pulled off old capacitator took off wire leads.Installed new one. Freezer runs great.Loaded it up with beef pork and venison. No problems.

I check why not defrost, y test element and tha problem is defrost timer, i ordered and change, that is it. Your intructions that is very nice.Thanks Ben

snapped the wires from frig onto the proper prong and viola,it works. The proper prong is identified by the size because there are two prongs with the wires and two connecting prongs in the socket. I talked to a very helpful representative and she gave me the number for Frigidaire, when I was confused by the placement of the wire. Wish I had remembered her name to share with you. As it turned out I didn't need to call Frigidaire.

Watch the video provided by PartSelect and did exactly the same percedure. Shows what screws to remove and how to remove and replace the part. The freezer compartment was iced up quite a bit so defrosted it before installing part.

The instructions given to me by part Select were very good.I replaced the Timer- checked the heater with oham meter it was good- checked the door weather striping it was good and replaced the thermostat with new .So at this point I may need to call a professional unless some one has another solution.

1 went with maj 69% said defrost timer. NO. 2 went with second choice run cap NO. 3 went with my thought, ( PTC Starter ) why not, most exp part. Fixed the problem.