All Installation Instructions for Westinghouse Refrigerator WRT18G4AW0

Handels

Replaced the handles looks alot better love them. Thank you ! :)

Parts Used:

Door Handle

Lonnie from Palestine, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Broken Drawer Support Rail And Door Handle

It was very easy. The handle to the door was a different than the original, but it fits. I should have brought the set, so they would match. It works, that all that matter.

Parts Used:

Drawer Support Rail - Right Side

Door Handle

CHRISTINE from STOCKTON, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

Was this instruction helpful to you?

Thank you for voting!

Retainer shelf ends broke off leaving just the retainer bar

Took out the old tabs that broke off (left inside the retainer bar) with a butter knife - just lifted very gently the ends to slip out the broken off old pieces then replaced with new pieces (pressed lifted sides back down with side of butter knife and then snapped back into door of fridge gently it will pop snap back in - So very very easy to do - should have done this years ago instead of living with taped ends and waiting until husband had time-smiles fridge looks new again do not wait - just do it order the pieces u need and you will be very happy U did

Parts Used:

5A - Door Shelf Retainer Bar End Cap - Right Side

6A- Door Shelf Retainer Bar End Cap - Left Side

stephen from Chicago, IL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

door wont close

its real easy, just by pulling the old gasket, in some spots the gasket was like glued, but with a flat screw driver a managed to pulled apart. finally,just attached the new gasket.

Parts Used:

Refrigerator Door Gasket

nestor from Edinburg, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

torn door gasket

Opened refrigerator door, opened a Corona, took a sip,removed old gasket from its track by simply pulling out of the track with my fingers; took another sip, installed new gasket by lining it up and pressing it into the track with my thumbs (It's good to have opposal digits) starting at the top center and progressing clockwise, closed refrigerator door, minus one Corona. Sat on the patio and enjoyed the rest of my Corona. Life's good!

Parts Used:

Refrigerator Door Gasket

Michael from Katy, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

Lower door bar broke.

Shipped quick. Assembled by hand. Mounted and tested operational.

Parts Used:

Refrigerator Door Shelf Retainer Bar - Cut to Fit

Door Shelf Retainer Bar End Cap - Right Side

Door Shelf Retainer Bar End Cap - Left Side

chris from Twin Falls, ID
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

The Drawer Support Right Side Broke At The Front Tab & The Drawer Fell Down

Took The Shelf Out That The Drawer Was Attached To.Turned It Upside Down.Took The 1 Phillips Screw Out At The Back That The Drawer Slide Was Attached To.Slid The Tab Into The Front Guide,Lined The Screw Hole In The Back Up And Replaced The Screw...Done...

Parts Used:

Drawer Support Rail - Right Side

Roberta from Clovis, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

loud noise fan blade broke,off balance

take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .

Parts Used:

Evaporator Fan Blade

EDWIN from ELWOOD, IN
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

Was this instruction helpful to you?

Thank you for voting!

Cracked gasket on fridge door

Used screwdriver to pry off edge of old gasket corner and peeled off old gasket. Snapped new gasket into door channel and made sure all the edges were seated. Took longer to open the shipping package than to do the repair.

Parts Used:

Refrigerator Door Gasket

Jay from Bethel Park, PA
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Replace a broken refrigerator door handle

Watched the video to see how it was done. Removed the two screws on top of the broken handle and remove broken part. Slide bottom of the handle on to the screw and replaced the two screws on top handle. Presto...all done in under five minutes. Ready for my next project.

Parts Used:

Door Handle

Howard from Columbia, SC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Refrigerator door handle broke.

Screwed in three screws. Easy!

Parts Used:

Door Handle

Luanne from Santa Rosa, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Side Rail To Drawer Broken

I ordered a new rail and it came up in one day. It took me 10 min to fix it

Parts Used:

Drawer Support Rail - Right Side

Lee from Warren, RI
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Fridge got warm and freezer coils were frosted

Defros timer was easy I finished it in about 15 minuts but the defrost themostat was hard.I had ploblems with the wire conectors and the tape I had to use Twist-on wire connectors.I hope I will not have problems later.So far 1 week later it is working.I can't belive $50 saves me $600.Thanks to Part Select for the video and how fast they shipping my parts in less than 2 days.

Parts Used: